Operating instructions

23
HT-SB300
2008 December 15
HT-SB300_A6_EN
References
Error indicators and warnings
When you fail to perform operations properly, the following
messages are displayed on the speaker.
(*): Should the same message appear even if the speaker is
unplugged and plugged in or is set to the stand-by mode and
on again, contact your local dealer where you purchased the
speaker.
Specifications
As part of our policy of continuous improvement, SHARP
reserves the right to make design and specification changes for
product improvement without prior notice. The performance
specification figures indicated are nominal values of production
speaker. There may be some deviations from these values in
individual speaker.
■ General
Display Meaning
●
Malfunction of the surround
circuit. Place the speaker away
from noise source and plug the
AC power cord into another AC
outlet. (*)
or
or
● When there is no input signal.
Play back the connected
equipment.
● Nonstandard signal. Cannot be
recognized.
Signals other than DOLBY
DIGITAL, DTS, Linear PCM
cannot be recognized.
●
Poor connection of the digital
audio input terminal.
Turn off the unit and check if the
cable is connected properly.
or
(Display blinks continuously)
Power indicator (blinks red)
● When the protection circuit is
activated.
Power source DC IN 12V 4A: AC/DC adaptor
(AC 100 - 240 V ~ 50/60 Hz)
Power
consumption
11 W
Maximum output
power
32 W
Speaker 2.1-way Speaker System
Front Speakers: 1-1/2" (38 mm) Full Range
Subwoofer: 2-1/4" (57 mm) Woofer (x4)
Input terminals Analog input (LINE 1):
RCA type x 1pair (L/R)
Analog input (LINE 2):
Stereo mini jack Ø 3.5 mm
Coaxial digital input (DIGITAL 1):
RCA type x 1
Optical digital input (DIGITAL 2):
Square type x 1
Audio output
terminals
Subwoofer Pre Out: 10 kOhms
Dimensions Width: 31-1/2" (800 mm)
Height: 3-3/4" (96 mm)
Depth: 2-3/4" (70 mm)
Weight 4.10 lbs. (1.85 kg)