Owner`s manual

9
1
7
6
5
4
3
2
1
9
2011 April 22
HT-SB600
E-3
Use the unit on a firm, level surface free from vibration.
Keep the unit away from direct sunlight, strong
magnetic fields, excessive dust, humidity and
electronic/electrical equipment (home computers,
facsimiles, etc.) which generate electrical noise.
Do not place anything on top of the unit.
Do not expose the unit to moisture, to temperatures
higher than 60°C (140°F) or to extremely low
temperatures.
If your system does not work properly, disconnect the
AC power lead from the wall socket. Plug the AC power
lead back in, and then turn on your system.
In case of an electrical storm, unplug the unit for safety.
Hold the AC power plug by the head when removing it
from the wall socket, as pulling the lead can damage
internal wires.
The AC power plug is used as a disconnect device and
shall always remain readily operable.
Do not remove the outer cover, as this may result in
electric shock. Refer internal service to your local
SHARP service facility.
This unit should only be used within the range of 5°C -
35°C (41°F - 95°F).
SHARP is not responsible for damage due to improper
use. Refer all servicing to a SHARP authorised service
centre.
Warning:
The voltage used must be the same as that specified on
this unit. Using this product with a higher voltage other
than that which is specified is dangerous and may
result in a fire or other type of accident causing
damage. SHARP will not be held responsible for any
damage resulting from use of this unit with a voltage
other than that which is specified.
To prevent fire or shock hazard, do not expose this
appliance to dripping or splashing. No object filled with
liquids, such as vases shall be placed on the apparatus.
The sound level at a given volume setting depends on
speaker efficiency, location, and various other factors. It is
advisable to avoid exposure to high volume levels. Do not
turn the volume on to full at switch on. Listen to music at
moderate levels.
This unit is fitted with a cooling fan at the rear for improved
cooling. Do not cover the opening in this section with any
obstacles.
Caution:
The unit will get warm whilst being used. Do not touch
the warm areas of the unit for prolonged periods to
avoid injuries.
This unit is equipped with a special function which
protects the amplifier circuit from damages. When it is
activated, the sound switch is turned off. In this case,
set the unit to the stand-by mode and turn on again.
Precautions
Please ensure that the equipment is positioned in a
well-ventilated area and ensure that there is at least
10 cm (4") of free space along the sides, top and back
of the equipment.
General
10 cm (4")
10 cm (4")
10 cm (4")
10 cm (4")
Volume control
Cooling fan