User Manual
Table Of Contents
- 日本語
- もくじ
- 安全上のご注意
- 各部のなまえ
- 操作ふたのネジ止めについて
- 設置場所
- 付属部品
- 設置のしかた
- 運転のしかた
- ブレーカー連動
- お手入れ
- プラズマクラスター発生ユニットの交換
- プラズマクラスターイオン発生ユニット
- 交換方法
- 仕 様
- 故障かな?
- ENGLISH
- CONTENTS
- IMPORTANT SAFETY INSTRUCTIONS
- PARTS NAME
- FIX THE OPERATION COVER BY SCREW
- INSTALLATION POSITION
- ACCESSORIES
- HOW TO INSTALL THE UNIT
- OPERATION
- AUTO RESTART
- CLEANING AND MAINTENANCE
- PLASMACLUSTER ION GENERATING UNIT REPLACEMENT
- Plasmacluster Ion Generating Unit for Replacement
- HOW TO REPLACE THE PLASMACLUSTER ION GENERATING UNIT
- SPECIFICATIONS
- TROUBLESHOOTING
- DEUTSCH
- INHALT
- WICHTIGE SICHERHEITSHINWEISE
- TEILEBEZEICHNUNG
- BEFESTIGUNG DER FUNKTIONSABDECKUNG MITEINER SCHRAUBE
- AUFSTELLPOSITION
- ZUSATZAUSRÜSTUNG
- AUFSTELLEN DES GERÄTES
- BETRIEB
- AUTO NEUSTART
- REINIGUNG UND PFLEGE
- AUSTAUSCH DER PLASMACLUSTER-IONENGENERIERENDEN EINHEIT
- Austausch der Plasmacluster-Ionen generierenden Einheit
- SO TAUSCHEN SIE DIE PLASMACLUSTER-IONENGENERIERENDE EINHEIT AUS
- TECHNISCHE DATEN
- FEHLERSUCHE
- FRANÇAIS
- CONTENU
- INSTRUCTIONS IMPORTANTES RELATIVES À LA SÉCURITÉ
- DÉSIGNATION DES PIÈCES
- FIXEZ LE COUVERCLE DE FONCTIONNEMENT AVEC LA VIS
- POSITION D’INSTALLATION
- ACCESSOIRES
- GUIDE D’INSTALLATION DE L’UNITÉ
- FONCTIONNEMENT
- REDÉMARRAGE AUTOMATIQUE
- NETTOYAGE ET ENTRETIEN
- REMPLACEMENT DE L'UNITÉ GÉNÉRATRICED'IONS D'IONS PLASMACLUSTER
- Remplacement de l’unité génératrice d’ions Plasmacluster
- COMMENT REMPLACER L’UNITÉGÉNÉRATRICE D’IONS PLASMACLUSTER
- CARACTÉRISTIQUES TECHNIQUES
- RÉSOLUTION DES PROBLÈMES
- NEDERLAND
- INHOUD
- BELANGRIJKE VOORZORGSMAATREGELEN
- BENAMING VAN DE ONDERDELEN
- MAAK DE BEDIENINGSBEHUIZING MET EENSCHROEF VAST
- PLAATS VAN INSTALLEREN
- ACCESSOIRES
- HOE DE UNIT INSTALLEREN
- BEDIENING
- AUTOMATISCH HERSTARTEN
- REINIGEN EN ONDERHOUD
- VERVANGING VAN PLASMACLUSTER ION GENERATING UNIT
- Vervanging Plasmacluster Ion Generating Unit
- HOE DE PLASMACLUSTER ION GENERATION UNIT TE VERVANGEN
- TECHNISCHE GEGEVENS
- PROBLEMEN OPLOSSEN
- РУССКИЙ
- СОДЕРЖАНИЕ
- ВАЖНЫЕ ИНСТРУКЦИИ ПО ТЕХНИКЕ БЕЗОПАСНОСТИ
- НАЗВАНИЯ УЗЛОВ
- УСТАНОВКА
- АКСЕССУАРЫ
- КАК УСТАНОВИТЬ БЛОК
- ЭКСПЛУАТАЦИЯ
- АВТО ПЕРЕЗАПУСК
- УХОД И ОБСЛУЖИВАНИЕ
- ЗАМЕНА БЛОКА PLASMACLUSTER ИОННОГО ГЕНЕРАТОРА
- Замена блока Plasmacluster ионного генератора
- КАК ЗАМЕНИТЬ БЛОК PLASMACLUSTER ИОННОГО ГЕНЕРАТОРА
- ТЕХНИЧЕСКИЕ ХАРАКТЕРИСТИКИ
- УСТРАНЕНИЕ НЕИСПРАВНОСТЕЙ
- ИНФОРМАЦИЯ О СЕРТИФИКАЦИИ ПРОДУКЦИИ
E-6
OPERATION
* This operation manual is based on IG-A40E.
The operation is same as IG-A20E.
Open the cover of Control Panel.
In case that the cover is fixed by a screw, take out the
rubber cover and a screw, and open the cover of control
panel.
Fix the cover of Control Panel.
As necessary, screw down the cover with the provided
screw and the washer and fi t in the rubber cover.
(Please see Page E-3)
Control
panel
Press the Operation Button to select the preferred mode.
LOW
Release high-density
Plasmacluster ions quietly.
MED
Release high-density
Plasmacluster ions at medium fan
speed.
HIGH
Increase the volume of high-
density Plasmacluster ions to
increase the purifi ying capacity.
Power 'OFF'
OPERATION BUTTON
AUTO RESTART
If the AUTO RESTART switch is set to "ON"
and the unit is accidently unplugged, the
circuit breaker trips of there is a power failure,
the unit will automatically start operation at the
previous setting power is restored.
AUTO RESTART
Switch
IG-A20EA40E.en.indd8IG-A20EA40E.en.indd8 2009/09/1713:39:072009/09/1713:39:07