User`s manual
Table Of Contents
- Safety Precautions
- Table of contents
- Chapter 1: Outline
- 1-1 Features
- 1-2 Controller
- 1-3 Measurement program
- [1] Positional deviation measurement
- [2] Degree of match inspection
- [3] Lead inspection
- [4] BGA/CSP inspection (IV-S32M/S33M)
- [5] Area measurement by binary conversion
- [6] Object counting by binary conversion
- [7] Object identification by binary conversion
- [8] Point measurements
- [9] Distance and angle measurement
- [10] Multiple position measurement (IV-S33M)
- [11] Multiple degree of match inspection (IV-S33M)
- Chapter 2 : Precautions for Use
- Chapter 3 : System Configuration
- Chapter 4 : Part Names and Functions
- Chapter 5 : Connection and Installation Methods
- Chapter 6 : Setting and Operating Outlines
- Chapter 7 : Simplified Menu Operation
- 7-1 Operation screen
- 7-2 Image display
- 7-3 Setting functions that are different with each controller
- 7-4 Setting procedures
- 7-5 Setting the operation conditions
- 7-6 Setting object types
- 7-7 Setting the shutter speed
- 7-8 Setting the positioning conditions
- 7-9 Setting the existence inspection conditions
- 7-10 Measurement triggering
- 7-11 Saving data
- 7-12 Specify the system conditions
- Chapter 8 : Specifications
- Chapter 9 : Operation Examples
- Glossary
- Appendix
- Alphabetical Index
5-1
5
Connection and Installation Methods
Label
Light beam
Light beam
Label detection
Light beam
Measurement of the center
coordinates of a hole
IV-S30C1
or similar
IV-S30C1
or similar
5-1 Installation conditions
[1] Lighting equipment
Lighting for the workpieces is an important factor in image processing. The lighting conditions affect the
measurement results. Select the proper lighting equipment.
- Make sure there is uniform illumination of the whole measurement field where object images will be
taken.
- Use flicker-free lighting equipment, such as a high frequency fluorescent lamps or halogen lamps.
- Consult us about the right lighting equipment for your application.
(1) Backlighting
Light should uniformly illuminate the field behind an object, so that the IV-S30 measure the object
with it's shadow. Since the shadow picture will be converted to binary values, reliable measurements
can be executed.
Example:
IV-S30C1
or similar
IV-S30C1
or similar
Miss-processed
product
Inspection of a processed part
Conveyor
Backlighting equipment
Light
Light
Hole inspection
Linear feeder
Backlighting using
surface illuminance LED
(2) Reflective lighting
A light shone on the front of an object with angle will be reflected, and the IV-S30 will pick up the
reflected light. If too much light is reflected, such as from a metallic surface or similar materials, a
proper image may not be obtained.
Example:
Chapter 5: Connection and Installation Methods