User`s manual
Table Of Contents
- Safety Precautions
- Table of contents
- Chapter 1: Outline
- 1-1 Features
- 1-2 Controller
- 1-3 Measurement program
- [1] Positional deviation measurement
- [2] Degree of match inspection
- [3] Lead inspection
- [4] BGA/CSP inspection (IV-S32M/S33M)
- [5] Area measurement by binary conversion
- [6] Object counting by binary conversion
- [7] Object identification by binary conversion
- [8] Point measurements
- [9] Distance and angle measurement
- [10] Multiple position measurement (IV-S33M)
- [11] Multiple degree of match inspection (IV-S33M)
- Chapter 2 : Precautions for Use
- Chapter 3 : System Configuration
- Chapter 4 : Part Names and Functions
- Chapter 5 : Connection and Installation Methods
- Chapter 6 : Setting and Operating Outlines
- Chapter 7 : Simplified Menu Operation
- 7-1 Operation screen
- 7-2 Image display
- 7-3 Setting functions that are different with each controller
- 7-4 Setting procedures
- 7-5 Setting the operation conditions
- 7-6 Setting object types
- 7-7 Setting the shutter speed
- 7-8 Setting the positioning conditions
- 7-9 Setting the existence inspection conditions
- 7-10 Measurement triggering
- 7-11 Saving data
- 7-12 Specify the system conditions
- Chapter 8 : Specifications
- Chapter 9 : Operation Examples
- Glossary
- Appendix
- Alphabetical Index
7-14
Simplified Menu Operation
7
[1] Setting the measurement conditions
Set the reference image area and the search area using rectangular windows.
ËË
ËË
Ë Setting procedure
1. Move the cursor to the "POSI-COND" item on the menu bar of the MAIN OPS MENU, and press
the SET key.
- The screen will change to the measurement condition setting screen.
Note
- Before setting the measurement conditions, make sure to select camera type (when the IV-
S33M is used: page 7-31), set the object type (page 7-11), and select camera (page 7-5).
2. Press the SEL key.
- The image will be displayed. The indicator in the upper right corner of the screen will change
from F (freeze) to T (through).
When the image is so bright that the menu display is difficult to see, press the TRG/BRT key to
reduce the brightness of the image. The indicator in the upper right corner of the screen will
change from "H" to "L."
3. To display the image of the object measured clearly, adjust the focus and iris opening of the
camera lens.
4. Move the cursor to the "1 REG" line, and press the SET key. Then, move the cursor to the "1P-
SCH" or "2P-SCH" item, and press the SET key.
- The image window and search window will be displayed in the center of the screen.
Image window
Search window
Object 1
Object 2
1REG NO 1P-SCH 2P-SCH
OPS-MENU
T.IMG C1 L
Press the TRG/BRT key on
the remote keypad, and the
brightness of the screen will
change between L and H.
Indicates that Camera 1 is
selected. (Camera 2: C 2)
Press the SEL key, and the
screen will switch between
the F.IMG (freeze mode)
and the T.IMG (through
mode).
1REG NO 1P-SCH 2P-SCH
OPS-MENU
F.IMG C1 H