User`s manual

4-5
Positional Deviation Measurement
4
RECTANGLE RESET RETURN
MDL
0
1
UP.L (224.208)
2 LO.R (287.271)
3 MOVE
4 REFERENCE IMG
SET=MOVE ESC=BACK SEL=CHNG IMG TRG=FUNC
F C1 BRT
Reference image area
Search area
REG-IMG
UP.L
LO.R
X:224 Y:208
Setting screen (RECTANGLE)
SET=MOVE ESC=BACK SEL=CHNG IMG TRG=FUNC
F C1 BRT
Reference image area
Search area
Y-LINE RESET RETURN
MDL
0
1
S.PT (194.175)
2 E.PT (194.344)
3 MOVE
4 REFERENCE IMG
X:199 Y:245
Start point
End point
Setting screen (Y-LINE)
SET=MOVE ESC=BACK SEL=CHNG IMG TRG=FUNC
F C1 BRT
Reference image area
Search area
X-LINE RESET RETURN
MDL
0
1
S.PT (199.245)
2 E.PT (328.245)
3 MOVE
4 REFERENCE IMG
X:194 Y:344
Start point
End point
Setting screen (X-LINE)
When a rectangle is selected
Specify the upper left and lower right corners of
the reference image area. Move the cursor to the
" UP.L" and press the SET key. Lines for the X
and Y axes will appear on the reference image
area (shown as a solid line). Move the X and Y
lines to the desired position using the up/down/
left/right arrow keys to set the coordinates for the
upper left corner. When correct, press the SET
key.
- To leave the coordinates at their previous
position, press the ESC key.
Next, move the cursor to the" LO.R" and press
the SET key to determine the lower right corner of
the rectangle. The range inside the rectangle of
the solid line becomes the reference image.
When a horizontal line is selected
Specify the start and end points on the X axis.
Specify the start and end points using the up/
down/left/right arrow keys. The points will move
along the X axis (while keeping the same Y
coordinate).
Note: Specify a search area longer than the
reference image area. Specifying a
shorter search area may cause an error
message to be displayed.
When a vertical line is selected
Specify the start and end points on the Y axis.
Specify the start and end points using the up/
down/left/right arrow keys. The points will move
along the Y axis (while keeping the same X
coordinate).
Note: Specify a search area longer than the
reference image area. Specifying a
shorter search area may cause an error
message to be displayed.