User`s manual

5-6
Degree of Match Inspection
5
When a vertical line is selected
Specify the start and end points on the Y
axis. Specify the start and end points using
the up/down/left/right arrow keys. The
points will move along the Y axis (while
keeping the same X coordinate).
Register a reference image
After setting the reference image area, store
an image in the controller as a reference
image.
Select " REFERENCE IMG" using the up/
down arrow keys and select "REG" from the
popup menu.
SEARCH ARE
Specify the search area (inside the dotted
lines) on the " SEARCH ARE (MDL0)" line,
using the same procedures used for setting
the reference image area.
Note: Set the menu for MDL1. Setting
procedures are the same as MDL0.
SET=MOVE ESC=BACK SEL=CHNG IMG TRG=FUNC
F C1 BRTY-LINE RESET RETURN
MDL
0
1
S.PT (194.175)
2 E.PT (194.344)
3 MOVE
4 REFERENCE IMG
X:194 Y:344
Setting screen (Y-LINE)
Crosshair cursor
(detection coordinate)
Solid line (reference line)
Dotted line (search line)
SERIAL NO.
8F053G26
MODEL
IV
-
S30MX
RECTANGLE RESET RETURN
MDL
0
1
UP.L (224.208)
2 LO.R (287.271)
3 MOVE
4 REFERENCE IMG
SET=MOVE ESC=BACK SEL=CHNG IMG TRG=FUNC
F C1 BRT
CONTRAST SRCH
REG
DISP
X:224 Y:208
SERIAL NO.
8F053G26
MODEL
IV
-
S30MX
SERIAL NO.
8F053G26
MODEL
IV
-
S30MX
RECTANGLE RESET RETURN
MDL
0
1
UP.L (224.208)
2 LO.R (287.271)
3 MOVE
SET=MOVE ESC=BACK SEL=CHNG IMG TRG=FUNC
F C1 BRT
X:224 Y:139
SERIAL NO.
8F053G26
MODEL
IV
-
S30MX
SERIAL NO.
8F053G26
MODEL
IV
-
S30MX