User`s manual

1-5
Setting and Operating Outline
1
[2] Configuration of the setting conditions
Operating
conditions
System
conditions
Object
type 00
Measuring
conditions
Object
type 01
・
・
・
Same for "Measurement 00."
Camera
1 and 2
Camera 1
and NG
images
The numbers in parenthesies ( ) are page numbers for your reference.
Output monitor (2-2), image capture (2-4), message display (2-5), pattern
display (2-6), binary image display (2-7), q angle correction, display operation
screen (2-9), display evaluation change (2-10), display PC monitor (2-11),
through display (2-11), extension function 2 (2-12).
- I/O conditions (17-1)
Measurement start input I/F, parallel input X6, parallel input X7, strobe output,
object type manual change (2-14)
- Communication setting (18-1)
Communication standard, communication speed, data length, parity, stop bit,
station number
- Computer link (19-1)
Manufacturer, station number, top line of the written results
- Gain/offset (2-15)
- System time (2-16)
- Camera setting (2-17)
Camera selection, image capture mode
Same for Camera 1 and 2. However,
"Measurement 0, Camera 2" is not
available.
Measurement 0,
camera 1
Measurement 0,
camera 2
Measurement 1
Measurement 2
Measurement 3
Measurement 4
Image pre-
processing (3-20)
Input and output for
each object type
System for
each object
Measuring program
Positional deviation
measurement
-
Positional deviation measurement, degree
of match inspection, lead inspection,
BGA/CSP inspection, area measurement
by binary conversion, object counting by
binary conversion, object identification by
binary conversion, point measurement,
multiple positions measurement, multiple
degree of match inspection.
CCD trigger (17-18), shutter speed (3-37), serial
output (17-24, 26), calibration setting (17-28).
Monitor light level (3-35), register NG images (3-39),
stop NG measurement (3-40), move whole window at
one time (3-41)
- See Chapter 4
See
Chapters
4 to 13.
Note: Maximum 16 object types (IV-S31MX), or 32 object
types (IV-S32MX/S33MX) can be registered.