User`s manual

7-2
7
BGA/CSP Inspection
SET=WINDOW SET ESC=BACK SEL=CHNG IMG TRG=POPUP
F C1 BRT
OBJECT TYPE COND
TYPE00
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEAS0
POSI-CORRECT
MEAS(NEW)
MEA-CND(CAMERA2)
FINAL NUM. CALC
FINAL OUTPUT COND
OBJ-TYPE I/0
OBJ-TYPE SYS.
TYPE(NEW)
SELECT OBJECT TYPE COND
+
+
1
MEAS SELECTION
NO
POSI-DEVATION
CHK-DEG-MATCH
INSPECT-LEAD
INSPECT-BGA/CSP
MEAS-BIN-AREA
CNT-BIN-OBJ
LABEL-BIN-OBJ
POINT-MEAS
MULTI-POSI
MULTI MATCHES
SET=SELECT A MENU ESC=BACK SEL=CHNG IMG TRG=FUNC
F C1 BRT
MEASUREMENT1 SCREEN COND SAVE
1
MEAS SELECTION INSPECT-BGA/CSP
7-2 Setting operation
Setting the measurement conditions
How to enter the measurement conditions setting screen
Select "MAIN-COND" -> "OBJECT TYPE
COND" (menu tree)-> "TYPE00" ->"MEA CND
(CAMERA1)" -> "MEAS(NEW)", in that order.
Then press the SET key to bring up the
"MEAS1" screen.
Move to the " MEAS SELECTION" line on
the "MEASUREMENT1" screen and select
"INSPECT-BGA/CSP" from the popup menu.
Press the ESC key to return to the "OBJECT TYPE COND" (menu tree) screen, and select the
"MEAS CND" item shown under "MEAS01 (INSPECT-BGA/CSP)" to go to the "MEA-CND" screen.
For details, see "Chapter 8: Setting Examples Using the Menu Tree" in the Introduction and
Hardware.