User`s manual

9-2
Object Counting by Binary Conversion
9
9-2 Setting operation
Setting the measurement conditions
How to enter the measurement conditions setting screen
Select "MAIN-COND" -> "OBJECT TYPE COND"
(menu tree)-> "TYPE00" ->"MEA-CND
(CAMERA1)" -> "MEAS(NEW)," in that order.
Then press the SET key to bring up the "MEAS1"
screen.
Move to the " MEAS SELECTION" line on the
"MEASUREMENT1" screen and select "CNT-BIN-
OBJ" from the popup menu.
Press the ESC key to return to the OBJECT TYPE COND (menu tree) screen, and select the "MEAS
CND" item shown under "MEAS01 (CNT-BIN-OBJ)" to go to the MEA-CND screen.
For details, see "Chapter 8: Setting Examples Using the Menu Tree" in the Introduction and
Hardware.
SET=WINDOW SET ESC=BACK SEL=CHNG IMG TRG=POPUP
F C1 BRT
OBJECT TYPE COND
TYPE00
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEAS0
POSI-CORRECT
MEAS(NEW)
MEA-CND(CAMERA2)
FINAL NUM. CALC
FINAL OUTPUT COND
OBJ-TYPE I/0
OBJ-TYPE SYS.
TYPE(NEW)
SELECT OBJECT TYPE COND
+
+
1
MEAS SELECTION
NO
POSI-DEVATION
CHK-DEG-MATCH
INSPECT-LEAD
INSPECT-BGA/CSP
MEAS-BIN-AREA
CNT-BIN-OBJ
LABEL-BIN-OBJ
POINT-MEAS
MULTI-POSI
MULTI MATCHES
SET=SELECT A MENU ESC=BACK SEL=CHNG IMG TRG=FUNC
F C1 BRT
MEASUREMENT1 SCREEN COND SAVE
1
MEAS SELECTION CNT-BIN-OBJ