User`s manual

10-8
Object Identification by Binary Conversion
10
Set the evaluation conditions
How to move to the evaluation condition setting screen
There are two methods for getting to the evaluation condition setting screen.
1) Select "COND" in the upper function menu on
the MEA-CND (or REG COND) screen and
press the SET key.Select "EVALUATION" on
the pop up menu to go to the EVALUAT
COND screen.
2) Move the cursor to the "EVALUATION COND"
item on the menu tree screen and press the
SET key.
The "EVALUAT COND"(evaluation conditions)
screen will appear.
For details about the evaluation conditions,
see page 3-18.
MEA-CND SCREEN COND SAVE
1 MEAS GRAV CENTER NO
2
WINDOW NORMAL
3
REGISTER NO.
0(0∼3)
4
REGISTER EXIST
NO
5 LABEL ORDER SCAN-ORDER
6 AX.ANGL NO
7
FILT NO
8
CIRC-L NO
9
MID-PNT NO
REGISTER NO.
0
BIN AREA COND
15141312111009080706050403020100
× ○ × ×
F C1 BRT
SET=SELECT A MENU ESC=BACK SEL=CHNG IMG TRG=FUNC
IMG PRE-PROC
REG COND
EVALUATION
DST&ANGL
NUM-CALC
OUT
F C1 BRTSELECT OBJECT TYPE COND
OBJECT TYPE COND
TYPE00
TYPE01
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEAS0
POSI-DEVIATION
MEAS01(CNT-BIN-OBJ)
IMG PRE-PROC
MEAS CND
REG-COND
EVALUATION COND
NUM-CALC
OUT-COND
MEAS(NEW)
MEA-CND(CAMERA2)
FINAL NUM. CALC
FINAL OUTPUT COND
OBJ-TYPE I/O
OBJ-TYPE SYS.
SET=TO NEXT SUB-MENU ESC=BACK SEL=CHNG IMG TRG=POPUP
+
+
1
REGISTER NO.
2 CONDITION SET
3 NUMBER OF OBJ
4 TOTAL AREA
5 TEST
1 REGISTER NO. 0(0~3) [TEST RESULT] [OUTPUT]
2 CONDITION SET AUTO(
±
10%)
3 NUMBER OF OBJ 000~128 K= NO
4 TOTAL AREA 000000~245760 A= NO
5 LABEL NO. 000(0~000)
6 OBJECT AREA 000000~245760 R= NO
MAIN AXIS ANGL B=
FILLET WIDTH FX=
FY=
PERIPHERAL CR=
MID POINT CX=
CY=
7 TEST EXEC(WITH-POSI.ADJ WITHOUT-POSI.ADJ)
SET=VALUE INPUT ESC=BACK SEL=CHNG IMG TRG=FUNC
F C1 BRTEVALUAT COND SCREEN COND SAVE EDIT SEL