User`s manual

10-9
Object Identification by Binary Conversion
10
Numeric calculation setting
- Press the TRG/BRT key to move the cursor to the upper function menu, and highlight "COND" using
the left and right arrow keys. Press the SET key to show the popup menu. Select "NUM-CALC" from
the popup menu.
- Select "NUM-CALC" on the menu tree.
See "Chapter 15: Numeric calculation."
Output condition setting
- Press the TRG/BRT key to move the cursor to the upper function menu, and highlight "COND" using
the left and right arrow keys. Press the SET key to display the popup menu. Select "OUT" from the
popup menu.
- Select "OUT-COND" on the menu tree.
See "Chapter 17: Set the Input/Output Conditions."
Display the measurement results
Return to the operation screen and press the TRG/BRT key. The measurement results will be displayed
on the screen.
F C1 BRT
V*.**
(TYPE00)
OK
MEAS XXXXms 2001-10-14 10:38
MEASUREMENT 1 LABEL-BIN-OBJ
REGISTER NO.0(0~3)
K=004 OK
A=006168 OK
LABEL NUMBER 000（000∼003）
R=001542 OK
GX=206.0 OK
GY=303.0
B=
＋ 028.0°
FX=042
FY=037
CR=00138.8
CX=
CY=
MNU-CHG MAIN-COND CHG-MEA COND-CHG CHNG-REG SCREEN-CHG CHG-TYPE
X0∼7 Y0∼7 READY
Final evaluation result
Measuring time
Measurement program
- CENT OF GRAV, MAIN AXIS
ANGL, FILLET WIDTH,
PERIPHERAL, or MID POINT
are displayed when
measurement of these
parameters has been specified
("YES" has been selected) on
the "MEAS COND" menu
(page 10-2).
Resistration number
in the measurement condition
NUMBER OF OBJECTS
TOTAL AREA
LABEL NUMBER
OBJECT AREA
CENTER OF GRAVITY
CORDINATE
MAIN AXIS ANGLE
FILLET DIA
PERIPHERAL