User`s manual

11-4
Existence Inspection by Point Measurement
11
POINT COND
Points which have been registered are marked with an "O."
- After being registered on the point condition setting screen, an "O" will be displayed in the
corresponding cells.
For details, see next page.
Setting the conditions (by selecting the point conditions)
How to enter the REG COND setting screen
This paragraph describes the setting for each point condition.
There are three ways to bring up the "REG COND" screen.
1) On the "MEA-CND" setting screen, move the
cursor to the " POINT COND" and press
the SET key. The cursor will move into the
table. Move the cursor to the "X" column and
press the SET key.
Note: After being registered, the "X" mark in a
corresponding cell is changed to "O."
2) On the "MEA-CND" setting screen, press the
TRG/BRT key to move the cursor to the
upper function menu. Select the "COND" item
and then select the "REG COND" item and
press the SET key.
3) On the menu tree, move the cursor to the
"MEAS CND" item, and press the right arrow
key. The sub menu which contains the "REG
COND" item will appear. Move the cursor to
this item and press the SET key.
F C1 BRTSELECT OBJECT TYPE COND
OBJECT TYPE COND
TYPE00
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEAS01(POINT-MEAS)
IMG PRE-PROC
MEAS CND
REG-COND
EVALUATION COND
NUM-CALC
OUT-COND
POSI-CORRECT
MEAS(NEW)
MEA-CND(CAMERA2)
FINAL NUM. CALC
FINAL OUTPUT COND
OBJ-TYPE I/O
OBJ-TYPE SYS.
SET=TO NEXT SUB-MENU ESC=BACK SEL=CHNG IMG TRG=POPUP
+
+
1
SIZE
2 EVALUATION
3 EVAL-SPEC(RATIO %)
4 REGISTER NO.
MEA-CND SCREEN COND SAVE
007006005004003002001000
× × × × × × ×
F C1 DRK
SET=SELECT A MENU ESC=BACK SEL=CHNG IMG TRG=FUNC
IMG PRE-PROC
REG COND
EVALUATION
NUM-CALC
OUT
1
MODE BINARY
2
BINARY PROCESS FIXED
3 THRESHOLD SET [U.LM255 L.LM100(0~255)]
4
CHNG-REG CHNG-REG
REGISTER NO.
5 POINT COND
×