User`s manual

11-7
Existence Inspection by Point Measurement
11
Set the evaluation conditions
How to move to the evaluation condition setting screen
There are two methods for getting to the evaluation condition setting screen.
1) Select "COND" in the upper function menu on
the MEA-CND (or REG COND) screen and
press the SET key.Select "EVALUATION" on
the pop up menu to go to the EVALUAT
COND screen.
2) Move the cursor to the "EVALUATION
COND" item on the menu tree screen and
press the SET key.
F C1 BRTSELECT OBJECT TYPE COND
OBJECT TYPE COND
TYPE00
TYPE01
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEAS0
POSI-CORRECT
MEAS01(POINT-MEAS)
IMG PRE-PROC
MEAS CND
REG-COND
EVALUATION COND
NUM-CALC
OUT-COND
MEAS(NEW)
MEA-CND(CAMERA2)
FINAL NUM. CALC
FINAL OUTPUT COND
OBJ-TYPE I/O
OBJ-TYPE SYS.
SET=TO NEXT SUB-MENU ESC=BACK SEL=CHNG IMG TRG=POPUP
+
+
+
+
1
PAGE CHNG
2 P001
3 P002
4 P003
5 P004
6 P005
7 P006
8 P007
9 P008
0 TEST
MEA-CND SCREEN COND SAVE
1
MODE BINARY
2
BINARY PROCESS FIXED
3 THRESHOLE SET [U.LM255 L.LM100(0~255)]
4
CHNG-REG CHNG-REG
REGISTER NO.
5 POINT COND
007006005004003002001000
× × × × × × × ×
F C1 DRK
SET=SELECT A MENU ESC=BACK SEL=CHNG IMG TRG=FUNC
IMG PRE-PROC
RED COND
EVALUATION
NUM-CALC
OUT