User`s manual

14-1
Distance and Angle Measurement
14
Chapter 14: Distance and Angle Measurement
14-1 Outline
You can specify the settings for distance and angle mesurement on the "MEAS COND" menu in the
positional deviation measurement, degree of match inspection, object identification by binary
conversion (select "YES" for center of gravity mesurement), multiple position measurement, and
multiple degree of match inspection.
page 4-3, 5-4, 10-5, 12-4, and 13-4
- For details about measuring the distance between two points, X coordinate distance, and Y
coordinate distance manually, see the MANL-MEAS (manual measurement) section (page 2-13) for
the crosshair cursor display.
Search area
(reference
image a)
Search area
(reference image b)
Reference image b
Reference image a
Purpose
Examples
The distance and angle of the centers of the detected points can be measured using
the center detection function and the edge detection function in a gray scale search
and the center of grevity detection function, which is a part of the labeling process.
- This function can measure the following distances and angles: distance between two
points, X coordinate distance, Y coordinate distance, the angle between three points,
the horizontal angle of two points, and the vertical angle of two points.
- The following points and lines can be set: center point, circle center point, gravity
center, point where two straight lines cross, line passing through two points.
Measurement for installed electronic components
[Measuring an IC package]
Reference images a and b are recorded when the crosshair cursor is placed on
the edge of the IC package.
- Measuring sequence
1 Obtain the center points of images a and b by running a 2 point gray scale
search.
2 Determine the distance between the two center points.
Applications