User`s manual

1-13
Setting and Operating Outline
1
1-4 Setting the measurement programs
To execute a specific measurement program (positional deviation measurement, degree of match
inspection, etc.), select MEASUREMENT 0 to 4 on the "MEA-CND" line.
- MEASUREMENT 0 only allows you to measure positional deviation.
- For details about the settings for each measurement program, see Chapters 4 to 14.
- Specify the conditions for distance and angle measurement in the positional deviation measurement,
the degree of match inspection, object identification by binary conversion (MEAS GRAV CENTR:
YES), multiple position measurement, and for multiple degree of match inspection.
(1) Operation main screen (see page 1-10).
(2) Select the "OBJECT TYPE COND" using the up
and down arrow keys and press the SET key.
(3) Move the cursor to the "TYPE(NEW)" item on the
"OBJECT TYPE COND" line and press the SET
key.
(4) Move the cursor to "TYPE00" on the "SELECT OBJECT TYPE COND" line and press the SET key.
To select "TYPE01" and others, move the cursor to "TYPE(NEW)" and press the SET key.
(5) Select "MEAS0 to 4" (MEAS0 is only used for positional deviation measurements) on the "MEAS
COND (CAM1)" line and a popup menu will appear. Select any desired measurement program from
this popup menu and then press the SET key.
（TYPE00）
F C1 BRT
V*.**
MEAS 0000ms 2001-10-14 10:38
X0~7
□□□□□□□□ Y0~7 □□□□□□□□ READY ■
MNU-CHG MAIN-COND CHG-MEA COND-CHG CHNG-REG SCREEN-CHG CHGTYPE
MEASURE 0 CAM1 NO
Move the cursor to the "MAIN COND" item using
the left and right arrow keys and press the SET key.
F C1 BRTMAIN MENU
IVS3*MX
SYS-CND
OBJECT TYPE COND
SET WIZARD
EDIT MAIN OPS MENU
OPTION
OBJECT TYPE COND
TYPE00
TYPE(NEW)
F C1 BRT
SELECT OBJECT TYPE COND