User`s manual

17-5
Setting the Input/Output Conditions
17
17-2 Measurement start input and result output settings
The combinations of various settings for item " MEAS INP I/F," item " START CCD SAMPL," and
item " ( )OUT I/F (PARAL.)" on the "I/O CONDITIONS" screen (page 17-1 to 4) are explained
below.
The time required to change object types is calculated differently according to the type of
measurement start input I/O, as follows:
Measurement start input I/F Time to change object type
Parallel Included in the measurement execution time
General-purpose serial Not included in the measurement execution time
CCD trigger Not included in the measurement execution time
Object type select switch (object type input)
- Parallel
Measurement
start input interface
Result output
Parallel → (1)
Computer link/parallel → (2)
General purpose serial/parallel → (3)
- General purpose
serial
- CCD trigger
General purpose serial/parallel → (4)
Parallel (Parallel) Parallel → (5)
Computer link/parallel → (6)
General purpose serial/parallel → (7)
General purpose
serial
(General purpose
serial)
General purpose serial/parallel → (8)
Auto Parallel
General purpose
serial
Parallel → (9)
General purpose serial/parallel → (10)
Start sampling
Object type
change
Result output
Controller Input terminal (model number)
IV-S31MX X1 to X4 (0 to 15: 16 object types)
IV-S32MX
X1 to X5 (0 to 31: 32 object types)
IV-S33MX