User`s manual

1-17
Setting and Operating Outline
1
1-8 Register and display NG images
NG image refers to any image that the controller has determined to be unacceptable after making the
measurements.
- NG images are registered in the controller’s memory. By replaying the NG images, you can review the
points with problems.
This section describes how to register, display, and initialize NG images. Depending on type of the
controller (IV-S31MX/S32MX/S33MX) you are using, some settings are not available.
* The left and right split screen display is not available using the monitor output.
[1] How to register NG images (IV-S32MX/S33MX)
When the IV-S32MX/S33MX is used, select "YES" for NG image registration. NG images will be
registered in the controller’s memory as they occur.
To make this setting, select " REGST NG IMG" on the [OBJ-TYPE SYS.] menu.
See page 3-39.
NG screen setting procedure
On the "SELECT OBJECT TYPE " screen, select
"MEA-CND (CAMERA2)" and press the TRG/BRT
key. From the popup menu, select "NG IMGS" and
press the SET key.
When the message shown on the right appears,
press the SET key.
metI XM13S-VI XM23S-VI XM33S-VI egapecnerefeR
segamiGNretsigeR
·
71-1
segamiGN
yalpsid
SPONIAM
unem
neercs
nehwyalpsiD
egamiGNna
srucco
12-1ot91-1
yrotsihyalpsiD
·
12-1
neercsyalpsidegamiGN
·
22-1
segamiGNezilaitinI
·
22-1
*
*
*
SET=TO NEXT SUB-MENU ESC=BACK SEL=CHNG IMG TRG=POPUP
F C1 BRT
OBJECT TYPE COND
TYPE00
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEA-CND(CAMERA2)
FINAL NUM. CALC
FINAL OUTPUT COND
OBJ-TYPE I/0
OBJ-TYPE SYS.
TYPE(NEW)
SELECT OBJECT TYPE COND
+
OPS-MENU
SAVE
NG IMGS
BY CHANGING A SETUP, THE CONTENTS OF SETTING IN A
CAMERA 2 WILL BE INITIALIZED. DO YOU CHANGE IT?
YES=SET, NO=ESC