User`s manual

17-20
Setting the Input/Output Conditions
17
THRESHOLD VAL
Specify the threshold value for binary
conversion.
Select this line and press the SET key. The
"THRESHOLD VAL" setting screen will appear.
For details, see pages 3-11 and 3-28.
INVERT B/W
(2) When "GRAY-SRC" is selected on the " TRIG
CCD START" line.
REF-IMG AREA
SEARCH AREA
DETECT CRD
CONTR. PIXEL
MATCH LEVEL
Specify the range for the degree of match
While " MATCH LEVEL" is selected, press the
SET key. The five digits for the lower limit will be
highlighted. Change the number using the up
and down arrow keys.
To change the value of individual digits, press
the SET key again. The cursor will move to the
leftmost digit. Adjust the value of each digit using
the up/down/left/right arrow keys.
When the value is correct, press the SET key. All
five digits will be highlighted again.
Then, press the left or right arrow key to move
the cursor to the next five digits, which are the upper limit. Adjust this number the same way.
(3) When "EDGE DTECT" is selected on the
" TRIG CCD START" line.
SEARCH AREA
DTECT MODE
SEARCH DIRECT
THRESHOLD VAL
F C1 BRTTHRESHOLD VAL AUTO-REG RESET
1
CRD-Y 050 （0∼255）
2 EDGE.W 2 （1∼8）
3
FLAT.W 04 （1∼16）
SET=CHNG ESC=BACK SEL=CHNG IMG TRG=FUNC
F C1 BRTCCD TRIG COND SCREEN SAVE
1 REF-IMG AREA SET (224.208)∼(287.271)
2 SEARCH AREA SET (216.200)∼(295.279)
3 DIRECT CRD CENTER (255.239)
4 CONTR.PIXEL 3
5 MATCH LEVEL +07000~+10000
SEL=WINDOW SET ESC=BACK SEL=CHNG IMG TRG=FUNC
F C1 BRTCCD TRIG COND SCREEN SAVE
SEL=WINDOW SET ESC=BACK SEL=CHNG IMG TRG=FUNC
1 SEARCH AREA SET (224.208)∼(287.271)
2 DTECT MODE CHNG POINT
3 SEARCH DIRECT HORIZ (→)
4 THRESHOLD VAL SET (D:050 E:2 F:04)
NO Do not reverse black and white areas.
YES
The area detected by binary
conversion will be displayed as white.
For details, see
pages 5-5 to 5-7.
For details, see
pages 12-7 to 12-9.