User`s manual
17-24
Setting the Input/Output Conditions
17
(2) When the measurement is started by a CCD trigger or a parallel I/F signal and the results are
output by a general purpose serial I/F signal
When the IV-S30 responds, data in a specified block is output after the output data (block 0) from the
measurement No. 0 to 4, in response to the measurement run command 2 (processing code 11(H)).
See page 18-7 for details about 1 and 2.
Note: The response returned by the measurement run command 2 (processing code 11(H)) will not
contain the specified block.
[2] Setting (operating) procedure
Setting (operating) procedure
1. Select "MAIN COND" -> "OBJECT TYPE
COND" -> "TYPE00" -> "OBJ-TYPE I/O" in
that order.
2. The "OBJ-TYPE I/O" screen will appear. Move
the cursor to " SERIAL OUTPUT" and press
the SET key. A popup menu will appear.
Select "BLOCK-ASSIGN" and press the SET
key.
■ Response
:11
Object
type
Output evaluation
results
RC
(H)
RC
(L)
Y15
Measurement 0
Measurement 0
Y1 …Y0
SC
(H)
SC
(L)
CR
1
Data in the
specified
block
Measurement 1
Measurement 2
Measurement 3
Measurement 4
Camera 1
data 2
Camera 2
data 2
Camera 1 Camera 2
Data from
measurement 1
data 2
Data from
measurement 2
data 2
Data from
measurement 3
data 2
Data from
measurement 4
data 2
SET=TO NEXT SUB-MENU ESC=BACK SEL=CHNG IMG TRG=POPUP
+
+
OBJECT TYPE COND
TYPE00
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEA-CND(CAMERA2)
FINAL NUM.CALC
FINAL OUTPUT COND
OBJ-TYPE I/O
OBJ-TYPE SYS.
TYPE(NEW)
SELECT OBJECT TYPE COND
F C1 BRT
1
TRIG CCD START
2
CCD TRIG COND
3
SHUTTER SPEED
4
SERIAL OUTPUT
5
SET SERIAL BLOCK
6
CAM NO
7
CALIBRATION
8
CALIBRATION
F C1 BRTOBJ-TYPE I/O SCREEN SAVE
SET=SELECT A MENU ESC=BACK SEL=CHNG IMG TRG=FUNC
1
TRIG CCD START NO
2
SHUTTER SPEED 1/00060(1/30~1/10000)
3
SERIAL OUTPUT BLOCK-ASSIGN
4
SET SERIAL BLOCK BLOCK00 MEAS0 CAM1
5
CAM NO 1(1~2)
6
CALIBRATION NO
ANY
BLOCK-ASSIGN