User`s manual

17-29
Setting the Input/Output Conditions
17
2. While the cursor is on the " CROSS
CURSOR" line on the CROSS CURSOR
screen, press the SET key. Move the
crosshair cursor to the tick marks on the ruler
using the up/down/left/right arrow keys and set
coordinate 1.
3. Then move the cursor on the CROSS
CURSOR screen to the " CUSOR2-
COORD" line and set coordinate 2 using the
same procedure.
4. Select the " SCALE" line and enter the actual value of the distance between coordinates 1 and
2. In this example, the distance is 10 mm. Therefore, enter "10."
5. Select the " SCALE(UNIT)" line and select the unit of distance between coordinates 1 and 2. In
this example, select "mm."
6. Select the " REG" (register) line and while the cursor is on "EXEC" (execute) press the SET
key again. The controller will be calibrated to read "1 pixel = 1 mm."
CLOSS CURSOR RESET RETURN
F C1 BRT
1
CLOSS CURSOR ( 256.240)
X:256 Y:200
10203040
CLOSS CURSOR RESET RETURN
F C1 BRT
1
CLOSS CURSOR ( 143.200)
X:143 Y:200
10203040