User`s manual

1-21
Setting and Operating Outline
1
NG2
NG6
OK1 NG2 OK3 OK4 OK5 NG6 OK7 OK8 OK9
Measured
image from
Camera 1
NG image
from
Camera 1
OK4 image
NG6 image
OK7 image
NG2 image
Refreshes to NG6 image
Camera 1
capturing
image
Camera 1
NG image
- When a maximum of 10 NG images is registered.
Display NG
image
history
NG image number 9
Measured
image from
camera 1
Up key
Down key
NG image number 10
Up key
Down key
NG image number 0
Display when an NG image is captured
The controller automatically refreshes the NG image each time a new NG image is captured.
[An example of the split screen display (above and below)]
Display history of NG images (IV-S32MX/S33MX)
When the IV-S32MX/S33MX is used, move the cursor to the menu bar "SCREEN-CHG" on the operation
main screen, using the left and right key. Select the "NG-IMG-DISP" from the popup menu to display
previous NG images.
[An example of scrolling the split screen display (above and below)]
When a new NG image is captured while displaying the history, it will be added to the history.
Note
- When "PARTIAL-IMG" is selected for image capturing (page 2-4), the NG images stored
have the maximum rectangular area set in measurements 0 to 4.
- When "CAM1&NG-IMG" is selected for the monitor output, only one camera* can be used
for each measurement (0 to 4) and for image pre-processing.
* The camera connected to the camera 1 connector (CAMERA 1).