User`s manual
18-16
Communication (General Purpose Serial Interface)
18
[4] Setting numerical data of the any output measuring
Numerical data of the any setting of the response at measuring (code 14(H): page 18-8) and reading
measurement data 4 (code 24(H): page 18-10) is as follows.
[Ex.] A numerical data of the any setting when outputting coordinate X and coordinate Y with the
positional deviation measurements.
:24RC
(H)
RC
(L)
SC
(H)
SC
(L)
CR
[Any type of numerical data]
Object
type
Measure-
ment code
Output
code
2
1
Station
No.
Execution
camera
Any numerical data
Registeration 0
(Model 1)
:
:
1 →Delimiter between output data:","(Space 20
(H) + comma 2C(H))
2 →Output code list
3 →Numeric result data
Output only the registered data in each specified
measurement, in register order.
Registeration 0
(Model 0)
Registeration N
(Model 1)
, 0 30 2
Registeration 0
(Model 0)
Registeration N
(Model 1)
Note: A maximum of 1 K bytes data is allowed.
[Ex.] Response to code 24
,
Numeric result data3
Codes and number of bytes of output data
1. Result of each measurement program
Output data Measurement program
Kind of output
Degree of match 01 2 O O
Coordinate X 02 2 O O
Coordinate Y 03 2 O O
Coordinate deviation X 04 2 O
Coordinate deviation Y 05 2 O
Angle 06 2 O
Average light level 1 07 2 O
Number of objects 08 2 O O O O O O
Distance
MAX. 09 2 O
MIN. 0A 2 O
Lead width
MAX. 0B 2 O
MIN. 0C 2 O
Lead length/
lead width 2
MAX. 0D 2 O
MIN. 0E 2
Total area 10 4 O O O O
Area of each
label
CUR. 11
4
O
MAX. 12 O
MIN. 13 O
X coordinate
of gravity
center/Distan-
ce between
gravity
centers X
CTR. OF
GRAVITY
14
2
O
MAX.
DIST.
15 O
MIN.
DIST.
16 O
Y coordinate
of gravity
center/Distan-
ce between
gravity
centers Y
CTR. OF
GRAVITY
17
2
O
MAX.
DIST.
18 O
MIN.
DIST.
19 O
Point
measurement
Output
code
Degree of match
inspection
Lead
inspection
BGA/SP
inspection
Area measurement
by binary
conversion
Object counting
by binary
conversion
Object
identification by
binary conversion
No. of
bytes
Multiple positions
measurement
Multiple degree of
match inspections
Positional
deviation
measurement