User`s manual

19-30
Computer Link
19
[4] Connection with an OMRON PC
Applicable models
Host link modules
1. C500-LK203 (C1000H) 4. CV CPU link port (CV1000, CVM1)
2. C200-LK201 (C200H RS-232C) 5. CV500-LK201 (CV1000, CVM1)
3. C200-LK202 (C200H RS-422) 6. CSIW-SCU21
* Enter the unit number of the IV-S30, as a component of CV500-LK201 system. When
communication port 1 is used, the unit number is fixed at 00, and when communication port 2 is
used, any number (00 to 31) can be used.
(1) Module setting
- Start the OMRON PC in the monitor mode when turning ON the power. If the OMRON PC is
started in any other mode, a computer link error will occur.
The operation mode is specified using the following items for each support tool: The initial mode
setting switch on the memory module, or the monitor mode rising bits of the system setting
(FUN49) instruction.
No support tool
Programming console
Program mode Monitor mode
Operation mode Monitor mode
Operation mode
Operation mode
01*1
Installed support tool
Memory module initial setting switch
Programming console setting mode *2
OFF
ON
The bit used to set the monitor
mode in the system setting
(FUN49) instruction
Support tools other than the
programming console
FUN49
#A302
000
000
00000
AR1001
*2 When the programming console is used, set the PC to the "monitor mode"
using the switch.
For details, see the user’s manual for the OMRON PLC module.
*1 Insert the ladder program step shown below at address 000000.
metI noitpircseD
.oNeludoM*13ot00
)ces/tibk(deepsnoissimsnarT6.9,2.91
leveldnammoC1
ytiraPneveroddO
edocnoissimsnarT
tibataD
tibataD)IICSA(7
tibpotS2
erudecorpN:1/1:1erudecorpN:1
hctiwsrevo-egnahcsuonorhcnySnoitazinorhcnyslanretnI
hctiwsrevo-egnahcSTC)NOyllamron(V0
hctiwsylppusV5FFO
Remarks