User`s manual

2-4
Setting the Operating and System Conditions
2
[2] Image capture
In item " CAPTURE IMG" on the "TYPE RUN COND"
screen, specify the range which will be captured during
operation.
Example of a comparison of the capture times
Capture whole image
Capture partial image
480 lines
240 lines
- Image capture mode (full/half mode)
- See page 2-20.
* The image capture time may vary with the
position of the partial image. (In the following
case, maximum 0.4 ms)
IV-S33MX
IV-S31MX/S32MX
8.3 ms (high-speed camera and full mode)*
4.2 ms (high-speed camera and half mode)*
12.5 ms (high-speed camera and full + half mode)*
16.6 ms (standard camera)
16.6 ms (standard camera)
IV-S33MX
IV-S31MX/S32MX
16.7 ms (high-speed camera and full mode)
8.3 ms (high-speed camera and half mode)
33.3 ms (standard camera)
33.3 ms (standard camera)
- When "WHOLE-IMG"is selected
- When the "PARTIAL-IMG" is selected (when there are 240 scan lines)
1 MONITOR OUTPUT CAM1
2 CAPTURE IMG PARTIAL-IMG
3 MESSAGE DISPLAY YES(NUMERIC)
4 PATTERN DISPLAY YES
5 SHOW BINARY IMG YES
6 SHOW θ FIX IMG YES
7 OPS MAIN DISP YES
8 DISP CHG-EVAL NO
9 PC-MNTR NO
0 THROUGH DISPLAY NO
q EXTENSION FUNC. NO
TYPE RUN COND SCREEN SAVE F C1 BRT
PARTIAL-IMG
WHOLE-IMG
NO
PARTIAL-IMG
(partial image)
WHOLE-IMG
(whole image)
NO
(no image)
Description
CAPTURE IMG
- No image will be captured during operation. Measurements will be
carried out with an image being displayed.
- This mode only used to carry out measurements on an image
transmitted from a personal computer to the IV-S30.
- A whole image will be captured, irrespective of the window settings for
inspection or measurement.
- This mode is used to monitor portions of an image outside the window
set up for inspection or measurement
- An image of the specified lines, required for inspection or measurement,
will be captured.
- The processing time is shorter than in the "WHOLE-IMG" mode.
Note: When the IV-S33MX is used and "EIA" is selected for the camera,
"PARTIAL-IMG" cannot be selected.
(The "PARTIAL-IMG" selection is not displayed.)