User`s manual

Setting the Conditions for Each Object Type
3-1
3
Chapter 3 : Setting Measurement Conditions
3-1 Outline
The measuring conditions for each object type are set on the "OBJECT TYPE COND"
(conditions for object type) menu.
Available object type numbers
How to enter the setting screen
On the MAIN MENU, move the cursor to "OBJECT TYPE COND" and
press the SET key. The "SELECT OBJECT TYPE COND" screen will
appear. Select "TYPE00," "MEA-CND(CAMERA1)," and "MEAS0" or
"MEAS(NEW)."
Note: "MEAS0" is only used for measuring positional deviation.
Choose a measurement program from the popup menu at
" MEAS SELECTION" to bring up the "MEAS CND" screen.
For details, see Chapter 8: "Setting Example Using the Menu
Tree" in the Instruction and Hardware.
Note: New meas urement programs are allocated to "MEAS01"
through "MEAS04." The smallest measurement number
available (from 1 to 4) will be assigned. "MEAS0" is
dedicated to positional deviation measurements.
0 to 31
0 to 15
IV-S31MX
IV-S32MX
IV-S33MX
+
+
+
+
+
+
OBJECT TYPE COND
TYPE00
TYPE01
TYPE02
TYPE03
TYPE04
TYPE05
TYPE(NEW)
SELECT OBJECT TYPE COND
+
+
OBJECT TYPE COND
TYPE00
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEAS0
POSI-CORRECT
MEAS (NEW)
MEA-CND(CAMERA2)
FINAL NUM.CALC
FINAL OUTPUT COND
OBJ-TYPE I/O
OBJ-TYPE SYS.
TYPE(NEW)
SELECT OBJECT TYPE COND
1 MEAS SELECTION POSI-DEVEATION
MEASUREMENT 1 SCREEN COND SAVE
NO
POSI-DEVIATION
CHK-DEG-MATCH
INSPECT-LEAD
INSPECT-BGA/CSP
MEAS-BIN-OBJ
LABEL-BIN-OBJ
POINT-MEAS
MULTI-POSI
MULTIMATCHES