User`s manual

Setting Measurement Conditions
3-4
3
TYPE RUN COND SCREEN SAVE
F C2 BRT
1 MONITOR OUTPUT NG IMGS
2 CAPTURE IMG PARTIAL-IMG
3 MESSSAGE DISPLAY YES(NUMERIC)
4 PATTERN DISPLAY YES
5 SHOW BINARY IMG YES
6 SOW θ FIX IMG YES
7 OPS MAIN DISP YES
8 DISP CHG-EVAL NO
9 PC-MNTR NO
0 THROUGH DISPLAY NO
q EXTERNSION FUNC. NO
CAM1
NG IMGS
CAM1&NG-IMG(HORIZ)
CAM1&NG-IMG(VERT)
SET=SELECT A MENU ESC=BACK SEL=CHNG IMG TRG=FUNC
SELECT CAMERA Description
CAM1&2
Camera 1 and camera 2 can be used for measurements (0 to 4) and for
image pre-processing.
CAM1&NG-IMG
Only camera 1 can be used for measurements (0 to 4) and image pre-
processing. Using camera 1, NG images can be displayed on the monitor.
- See page 1-19.
OBJECT TYPE COND
TYPE00
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEA-CND(CAMERA2)
FINAL NUM.CALC
FINAL OUTPUT COND
OBJ-TYPE I/O
OBJ-TYPE SYS.
TYPE(NEW)
+
SELECT OBJECT TYPE COND F C2 BRT
1 MONITOR OUTPUT
2 CAPTURE IMG
3 MESSAGE DISPLAY
4 PATTERN DISPLAY
5 SHOW BINARY IMG
6 SHOW θ FIX IMG
7 OPS MAIN DISP
8 DISP CHG-EVAL
9 PC-MNTR
0 THROUGH DISPLAY
q EXTENSION FUNC.
w DISPLAY+CURSOR 1
e CLOSS CURSOR COORD
r DISPLAY+CURSOR 2
t CLOSS CURSOR COORD
SET=TO NEXT SUB-MENU ESC=BACK SEL=CHNG IMG TRG=POPUP
3-2 Shared settings
[1] Camera selection
Specify which cameras to use (Camera 1, Camera 2) in "MEA-CND" on the "OBJECT TYPE COND"
menu for each object type.
Note: Before choosing the NG screen, you will first have to change Camera 2 to NG screen.
For details, see page 1-17
When the select camera is çhanged from "CAM1&2" to "CAM1&NG-IMG," the setting details for
"MEASURE0 CAM2" and "MEASUREMENT1 to 4" are initialized.
Setting method
To set the output to the monitor, select " MONI-
TOR OUTPUT" on the "TYPE RUN COND" menu.
1. On the "OBJECT TYPE COND" screen, select
"TYPE00" and "TYPE RUN COND."
2. On the "TYPE RUN COND" scree, select
" MONITOR OUTPUT." Then, select "NG-
IMGS" from the popup men.