User`s manual

1-5
Setting and Operating Outline
1
[2] Configuration of the setting conditions
Operating
conditions
System
conditions
Object
type 00
Measuring
conditions
Object
type 01
・
・
Object
type 15
Same for "Measurement 00."
Camera
1 and 2
Camera 1
The numbers in parentheses ( ) are page numbers for your reference.
Output monitor (2-2), image capture (2-4), message display (2-5), pattern
display (2-6), binary image display (2-7),
θ angle correction image display (2-
8), operation main display (2-9), evaluation change display (2-10), PC monitor
screen (2-11), through display (2-11), extension functions (2-12).
- I/O conditions (16-1)
Measurement start input I/F, parallel input X5, parallel input X6, strobe output
- Object type manual change (2-14)
- Communication setting (17-1)
Communication standard, communication speed, data length, parity, stop bit,
station number
- Computer link (18-1)
Manufacturer, station number, top line of the written results
- Gain/offset (2-15)
Same for Camera 1 and 2. However,
"Measurement 0, Camera 2" is not
available.
Measurement 0,
camera 1
Measurement 0,
camera 2
Measurement 1
Measurement 2
Measurement 3
Measurement 4
Image pre-
processing (3-20)
Input and output for
each object type
System for
each object
Measuring program
Positional deviation
measurement
-
Positional deviation measurement, degree
of match inspection, lead inspection, area
measurement by binary conversion, object
counting by binary conversion, object
identification by binary conversion, point
measurement, multiple positions
measurement, multiple degree of match
inspection.
CCD trigger (16-18), shutter speed (3-36), serial
output (16-24, 26), calibration setting (16-28).
Monitor light level (3-34), stop NG measurement (3-
38), window group move (3-39)
- See Chapter 4
See
Chapters
4 to 12.