User`s manual

2-10
Setting the Operating and System Conditions
2
[8] Evaluation change display
Specify whether the evaluation condition change
menu can be displayed on the operation screen or
not.
Select the " DISP CHG-EVAL" line on the "TYPE
RUN COND" screen and select "YES" on the popup
menu.
Press the TRG/BRT key to move the cursor to the
upper function menu. Select "SCREEN" and press the
SET key. Then select "OPS-MENU."
Select "SCREEN-CHG" on the lower menu on the
operation screen, and press the SET key. "JDG-
COND CHG" will be displayed in the lower right
corner of the screen. You can display the evaluation
condition change menu by pressing the up and down
keys.
- Press the SET key. The cursor will move to the
area containing the phrase "evaluation condition
change menu during operation." You can change
the settings for the evaluation conditions.
-At this time, the screen display will look the same
as the normal operation main screen, except for
the area marked "evaluation condition change
menu shown during operation."
1 MONITOR OUTPUT CAM1
2 CAPTURE IMG PARTIAL-IMG
3 MESSAGE DISPLAY YES(NUMERIC)
4 PATTERN DISPLAY YES
5 SHOW BINARY IMG YES
6 SHOW θ FIX IMG YES
7 OPS MAIN DISP YES
8 DISP CHG-EVAL YES
9 PC-MNTR NO
0 THROUGH DISPLAY NO
q EXTENSION FUNC. NO
TYPE RUN COND SCREEN SAVE F C1 BRT
SET=SELECT A MENU ESC=BACK SEL=CHNG IMG TRG=FUNC
YES
NO
1 MONITOR OUTPUT CAM1
2 CAPTURE IMG PARTIAL-IMG
3 MESSAGE DISPLAY YES(NUMERIC)
4 PATTERN DISPLAY YES
5 SHOW BINARY IMG YES
6 SHOW θ FIX IMG YES
7 OPS MAIN DISP YES
8 DISP CHG-EVAL NO
9 PC-MNTR NO
0 THROUGH DISPLAY NO
q EXTENSION FUNC. NO
TYPE RUN COND SCREEN SAVE F C1 BRT
OPS-MENU
MAIN
SELECT
RETURN
X0∼6 □□□□□□□□ Y0∼7 □□□□□□□□ READY ■□
(TYPE00)
F C1 BRT
MEAS 0000ms
MEASURE 0 CAM1 NO
MNU-CHG MAIN-COND CHG-MEA COND-CHG CHNG-REG SCREEN-CHG CHG-TYPE
JDG-COND-CHG
PC-MNTR
Display evaluation condition
change menu while in operation