User`s manual

2-14
Setting the Operating and System Conditions
2
2-2 Setting the system conditions
Set the following items on the "SYS-CND" menu to set
the system conditions for the controller.
Setting item
- Input/output conditions
- Communication setting
- Computer link
- Gain/offset
For the following items, see the pages listed
below.
- Input/output conditions Chapter 16
- Communication setting Chapter 17
- Computer link Chapter 18
[1] Manually setting the object type
On the operation screen, the object type (00 to 15) can
be changed manually (using the remote keypad).
On the MAIN MENU, select "SYS-CND" -> "I/O
CONDITIONS" -> " MANL TYPE CHNG" in that
order and then select "YES" or "NO" on the popup
menu.
The type can be manually changed on the
operation screen.
Note: If the "3MANL TYPE CHNG" is set to
"YES," the type cannot be changed
with an external interface (parallel I/O
or general purpose serial interface).
YES
NO
Description
MANL TYPE
CHNG
The type cannot be manually changed on the
operation screen.
MAIN MENU F C1 BRT
IVS30J
SYS-CND
OBJECT TYPE COND
SET WIZARD
EDIT MAIN OPS MENU
OPTION
SET=TO NEXT SUB-MENU ESC=BACK SEL=CHNG IMG TRG=POPUP
SYS-COND
I/O CONDITIONS
COMM-SET
COMPUTER LINK
GAIN-OFFSET
SYSTEM COND SET
F C1 BRT
1 MEAS INP I/F
2 OUT I/F(PARAL.)
3 MANL TYPE CHNG
4 PARALLEL INP X5
5 PARALLEL INP X6
6 STROBE OUT
7 ’READY’ON
SET=SELECT A MENU ESC=BACK SEL=CHNG IMG TRG=POPUP
1 MEAS INP I/F PARALLEL+SERIAL
2 OUT I/F(PARAL.) NO
3 MANL TYPE CHNG NO
4 PARALLEL INP X5 EXT-INP
5 PARALLEL INP X6 EXT-INP
6 STROBE OUT NO
7 ’READY’ON CAPTURE COMPLETE
I/O CONDITION SCREEN COND SAVE
F C1 BRT
SET=SELECT A MENU ESC=BACK SEL=CHNG IMG TRG=FUNC
NO
YES