User`s manual

6-5
[5] Setting screen for display ladder chart
(1) Initial setting in order to use the ladder monitor (Select from edit items).
Select "System setting" → "Other settings" → Make possible to use the ladder monitor on the P3
menu.
Click the check box " □ Use Ladder Monitor." (See the figure below.)
If you cannot put check mark because the characters are changed to meaningless symbols, reset the
PLC type to "SHARP: PG port."
(2) Set for overlap display of ladder chart on a screen to you want to display.
Move to an edit screen you want to display.
Click the overlap icon on the part edit screen of the software.
The "Overlap Setting" dialog shown below appears. Select "No. 0 Overlap" → "Call."
This call overlap will be a button switch that is used to display ladder chart.