User`s manual

6-23
Display open macro setting of multi overlap No. 1
When the multi overlap is opened, the LCD control terminal turns ON the numeric key memory $u0700
write enable bit (0th line), and makes possible numeric key input.
The LCD control terminal first lights the "Coil" lamp and waits for coil number input. (1st to 2nd lines)
(5) Any coil No. search instruction
If you want to search for any memory coil, but not search for a coil of the switch lamp memory, execute with
the following procedures.
- SET
-
LDR: COIL
-
FIND
Display setting of macro block No. 12 (Search option coil: Execute with CALL 12)
When searching for any coil, register the following formula for the ON macro of the starting up
switch
Ex.: If you want to arrange detects OUT 04000 by pressing a certain switch, enter 04000(W)(OCT)
to $u0200 with octal constant.
With this, set the lamp memory of the switch to coil 6000 and when 6000 turns ON (error condi-
tion), the LCD control terminal displays ladder circuit of coil 04000 (a coil to check).
Link to option memory
$u0200.
Assign option memory.