User`s manual

3-1
Chapter 3: System Configuration
*1: Prepare this connection cable separately. A D-sub 25P connector (male) is used for
connecting to the display terminal and is supplied as an accessory.
*2: The ZM-80C cable is sold separately.
*3: The ZM-80PC connection cable is sold separately.
Connection
- When installing a communication module in the PC, we recommend connecting a programming tool to the
control module and then you can connect the LCD control terminal (ZM series) to this communication
module.
- When using a JW-20CM, more than one LCD control terminal (ZM series) can be connected to the PG
ports of a single JW-20CM (multi-link connection). See page 4-2.
ZM-71SE
The following programs are supplied to allow use of the ladder monitor function. These programs are stored
in the "C: ¥ Program Files ¥ Zm71se ¥ Data ¥ Ladder ¥ " folder when the ZM-71SE software is installed for
the first time.
(Instructions for use See page 6-2.)
- Basic screen data
ZM-82/72TS series: LADDER82.Z71
ZM-72/52 series: LADDER72.Z71 ← Except the TS series for the ZM-72
ZM-42/43 series: LADDER42.Z71
- Communication I/F driver: SHARPPG.TPB version V1.200 or later
*1
Connection cable
(When operating)
(When sending
an image)
*2
Cable
ZM-80PC
Communication module
Personal computer
Communication
module name
PC model name
JW-22CM
JW-21MN
(Hard copy)
*3
Connection cable
ZM-80PC
Printer
NEC: PC-PR201 series
EPSON: ESC/P24-J84, ESC/P super function
HP (Hewlett Packard): PLC Level 3
Windows 95/98/NT4.0 version
V1.3.0.0 or later
PG port on a
SHARP PC
(Connector for a
support tool)
Control module name
JW-50CU/70CU/100CU
JW-50CUH/70CUH/100CUH
JW-21CU/22CU
JW-32CUH/H1
JW-33CUH/H1/H2/H3
JW50/70/100
JW50H/70H/100H
JW20/20H
JW30H
JW50/70/100
JW50H/70H/100H
JW20/20H
JW30H
ZM-71SE screen editor software
for ZM series display terminals
ZW-20CM
JW-20CM
JW-20RS
JW-20MN
PC model name
(ZM-**)