Manual

PREPARE THE HOOD
1 Remove 7" Round 7" ROUND
Duct Plate from top DUCTPLATE
of hood. Set duct
plate aside - with
mounting screws.
2Remove tape
holding Filters in
place. Pull down
on filter tabs or
finger holes and
lift filters out. Set
filters aside.
FILTERS X
i
3 Remove Teflon %
Coated Bottom
Cover froln hood.
Set cover and
mounting screws
aside.
Tq/lon _ is' a regismred
trademark qf DuPont.
4 Remove Damper/
Duct Connector
from inside the
hood. Set com_ector
aside- withmounting
screws and parts
bag.
5 Remove either top
or back wiring
knockout and install
approved Electrical
Cable Clamp.
NON-DUCTED INSTALLATION - Skip to page 8.
The following Steps (6 thru 14) are for DUCTED
INSTALLATION ONLY.
(3)#8 SCREWS LIGHT
PANEL
6Remove Light
Panel - held in
place with (5) #8
screws. Disconnect
light assembly
wire harness
(white connector).
7 Remove Air Chute
- held in place with
one (1) screw.
Note: Be careful
not to disconnect
any wires.
AIR CHUTE
\
TEFLON_)-COATED BOTTOM COVER
(Held in place with 2 screws)
DAMPER/DUCTCONNECTOR
ELECTRICAL CABLE CLAMP
8 Remove Baffle from air chute.
\
BAFFLE
Rotate baffle.
Reinsert baffle
into air chute
(as shown) so
that baffle Tabs
fit all the way
into Slots in air
chute. An audible
"click" will be
heard when fully
installed. This
will close offthe
air flow through
the non-ducted
slots on top of
hood.
SLOTS
BAFFLE
SUPPORT FIN