Installation manual

ManualsBrandsSharp ManualsCooktopKB-3411JK

INSTALLATION MANUAL

SPECIAL WARNING

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.

IMPORTANT: SAVE THIS INSTALLATION MANUAL FOR LOCAL ELECTRICAL

INSPECTOR’S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

CLEARANCES & DIMENSIONS

For SAFETY CONSIDERATIONS do not install a range in any combustible cabinetry which is not in

accord with the stated clearances and dimensions on page 2. See Figures 1 and 2.

RANGE MEASUREMENTS ......................................2

CLEARANCES AND DIMENSIONS ..............................2

IMPORTANT NOTES .............................................

UNPACKING AND EXAMINING YOUR RANGE .................

IMPORTANT SAFETY INSTRUCTIONS .........................

ELECTRICAL CONNECTIONS ................................ 3-5

ADJUSTABLE BACKSPLASH ...................................

ANTI-TIP .......................................................7

MODEL AND SERIAL NUMBER LOCATION ....................

CARE, CLEANING AND MAINTENANCE ......................8

ELECTRIC RANGE WITH MICROWAVE DRAWER

30” Freestanding Range

Summary of content (8 pages)

PAGE 1
INSTALLATION MANUAL SPECIAL WARNING INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE THIS INSTALLATION MANUAL FOR LOCAL ELECTRICAL INSPECTOR’S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. CLEARANCES & DIMENSIONS For SAFETY CONSIDERATIONS do not install a range in any combustible cabinetry which is not in accord with the stated clearances and dimensions on page 2. See Figures 1 and 2. RANGE MEASUREMENTS ......................................
PAGE 2
INSTALLATION MANUAL RANGE MEASUREMENTS 30" 29 7/8" minimum 30" to bottom of cabinet over cooktop 29 5/8" adjustable backsplash width 18" to upper cabinets 42-48" with adjustable backsplash 36±1/8" to cooktop surface 42" drawer open 6" 6 1/8" 6" 36" countertop height 6 1/8" Maximum depth of cord, plug and receptacle box 4" to prevent interference with lower oven 27" back to front of doors Figure 1 45 3/8" oven door open 7 3/8" 4" Preferred electrical outlet area 30" opening width 30" doo
PAGE 3
INSTALLATION MANUAL the ﬂoor covering can withstand heat at least 90˚F (32.2˚C) above room temperature without shrinking, warping or discoloring. Do not install the range over carpeting unless you place an insulating pad or sheet of 1/4-inch (0.64cm) thick plywood between the range and carpeting. UNPACKING AND EXAMINING YOUR RANGE 1 Remove all packing materials f r o m i n sid e t h e Microwave Drawer and the oven cavity.
PAGE 4
INSTALLATION MANUAL 4-wire wall receptacle (14-50R) Risk of fire or electrical shock exists if an incorrect size range cord kit is used or the Installation Manual or strain relief clamp are disregarded. CAUTION Do not loosen the nuts which secure the factory- installed range wiring to the terminal block while connecting range. Electrical failure or loss of electrical connection may occur.
PAGE 5
INSTALLATION MANUAL 3-WIRE CONNECTION INSTRUCTIONS Before wiring the range, review the suggested power source location drawings in Figure 2. If connecting to a 4-wire electrical system: For existing installations ONLY, refer to Figure 9. 1 Follow the power supply kit manufacturerʼs Installation Instructions supplied with the strain relief clamp and install. See Figure 7. 2 Insert the end connectors for line 1, line 2 and neutral and tighten securely to the terminal block. See Figure 7.
PAGE 6
INSTALLATION MANUAL IMPORTANT ADJUSTABLE BACKSPLASH This backsplash must be installed before the range is moved into place. The range backsplash is adjustable so that you can customize it for your particular kitchen situation. The height can be adjusted from the low position (6-inches high) to the highest position (12-inches high) in one inch increments. 1 Remove the screws from the cooktop back frame end cap on both sides and the screws from the range back cover on both sides, as shown in Figure 12.
PAGE 7
INSTALLATION MANUAL 2 DRILL PILOT HOLES AND FASTEN BRACKET ANTI-TIP Drill a 1/8-inch pilot hole where screws are to be located. If bracket is to be mounted to the wall, drill pilot hole at an approximate 20 degree downward angle. If bracket is to be mounted to masonry or ceramic ﬂoors, drill a 5/32-inch pilot hole 1 3/4-inches deep. The screws provided may be used in wood or concrete material. Use a 5/16 -inch nut-driver or ﬂat head screwdriver to secure the bracket in place.
PAGE 8
INSTALLATION MANUAL MODEL AND SERIAL NUMBER LOCATION BEFORE YOU CALL FOR SERVICE Read the BEFORE YOU CALL and operating instruction sections in your Operation Manual. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this range. The name plate, including model and serial number, is located on the faceplate behind the Microwave Drawer front.