Installation manual

ManualsBrandsSharp ManualsMicrowave OvenKB-3425L

InstallatIon Manual

sPECIal WaRnInG

InstallatIon anD sERVICE Must BE PERFoRMED BY a QualIFIED InstallER.

IMPoRtant: saVE thIs InstallatIon Manual FoR loCal ElECtRICal

InsPECtoR’s usE.

REaD anD saVE thEsE InstRuCtIons FoR FutuRE REFEREnCE.

ClEaRanCEs & DIMEnsIons

For SAFETY CONSIDERATIONS do not install a range in any combustible cabinetry which is not in

accord with the stated clearances and dimensions on page 2. See Figures 1 and 2.

RanGE MEasuREMEnts ......................................2

ClEaRanCEs anD DIMEnsIons ..............................2

IMPoRtant notEs .............................................2

unPaCkInG anD ExaMInInG YouR RanGE .................3

IMPoRtant saFEtY InstRuCtIons .........................3

ElECtRICal ConnECtIons ................................ 3-5

MoDEl anD sERIal nuMBER loCatIon ....................4

antI-tIP ..................................................... 6-7

CaRE, ClEanInG anD MaIntEnanCE ......................7

notEs ..... .......................................................8

ElEctric rangE With MicroWavE DraWEr

30" Freestanding Range

Summary of content (8 pages)

PAGE 1
Installation Manual SPECIAL WARNING INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE this installation manual FOR LOCAL ELECTRICAL INSPECTOR’S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. Clearances & Dimensions For SAFETY CONSIDERATIONS do not install a range in any combustible cabinetry which is not in accord with the stated clearances and dimensions on page 2. See Figures 1 and 2. Range Measurements.......................................
PAGE 2
Installation Manual Range Measurements 30" minimum 30" to bottom of cabinet over cooktop 29 7/8" 18" to upper cabinets 44 3/8±1/8" backsplash 36 1/8" to cooktop surface 42" drawer open 6" 6 1/8" 6" 6 1/8" 27" back to front of doors 45 3/8" oven door open 36" countertop height Maximum depth of cord, 7 3/8" plug and receptacle box is 4" to prevent interference with lower oven.
PAGE 3
Installation Manual • Before installing the range in an area covered with linoleum or any other synthetic floor covering, make sure the floor covering can withstand heat at least 90˚F (32.2˚C) above room temperature without shrinking, warping or discoloring. Do not install the range over carpeting unless you place an insulating pad or sheet of 1/4-inch (0.64cm) thick plywood between the range and carpeting.
PAGE 4
Installation Manual 3 & 4-Wire electrical wall receptacle types & recommended mounting orientation on wall Risk of fire or electrical shock exists if an incorrect size range cord kit is used, or the installation instructions are not followed precisely and/or a strain relief clamp is not used. Figure 5A illustrates 4-wire receptacle required for new and remodeled installations. Do not loosen the nuts which secure the factory-installed range wiring to the terminal block while connecting range.
PAGE 5
Installation Manual frame where the ground screw was originally installed. See Figure 8. 5 Make sure all screws are tightened securely and replace the rear access cover and secure with screw. See Figure 6. 3 & 4-WIRE PERMANENT WIRE CONNECTIONS 3–wire permanent connection – follow steps 1, 2 and 5 below. 4–wire permanent connection – follow all steps below. Before wiring the range, review the suggested power source location drawings in Figure 2.
PAGE 6
Installation Manual Mark the floor or wall where left or right side of the range will be located. If rear of range is against the wall or no further than 1 1/4 -inches from wall when installed, you may use the wall or floor mount method. See Figure 13. If molding is installed and does not allow the bracket to fit flush against the wall, remove molding or mount bracket to the floor.
PAGE 7
Installation Manual A minimum clearance of 1/8-inch is required between the bottom of the range and the leveling leg to allow room for the bracket. Use a level to check your adjustments. Plug range into properly prepared electrical receptacle or if hard wired, check that it was completed properly. Check floor condition for evenness and stability. Slide range back into position. See Figure 18.
PAGE 8
Installation Manual Care, Cleaning and Maintenance Refer to the Operation Manual for cleaning instructions. If removing the range is necessary for cleaning or maintenance, disconnect the electrical power supply. If the electrical supply is inaccessible, lift the unit slightly at the front and pull out away from the wall. Pull only as far as necessary to disconnect the electrical supply. Finish removing the unit for servicing and cleaning.