Installation guide

ManualsBrandsSharp ManualsMicrowaveOfficial Sharp electric range with microwave drawer

30" FreestandingRange

iNSTALLATiONANDSERVICEMUSTDEPERFORMEDBYAQUALiFiEDiNSTALLER,

iMPORTANT: SAVE THiS iNSTALLATiON MANUAL FOR LOCALELECTRICAL

iNSPECTOR'S USE,

READANDSAVETHESEiNSTRUCTiONSFORFUTUREREFERENCE,

ForSAFETYCONSiDERATiONSdonotinstall a rangein anycombustibJecabinetrywhichis notin

accordwiththe statedclearancesand dimensionson page 2. See Figures1 and2.

RANGEMEASUREMENTS...................................... 2

CLEARANCESANDDiMENSiONS.............................. 2

IMPORTANTNOTES............................................. 2

UNPACKINGANDEXAMININGYOURRANGE................. 3

IMPORTANTSAFETYINSTRUCTIONS......................... 3

ELECTRICALCONNECTIONS................................ 3-5

MODELANDSERIALNUMBERLOCATION.................... 4

ANTI-TIP ..................................................... 6-7

CARE,CLEANINGANDMAINTENANCE...................... 7

NOTES............................................................ 8

® Insight '_

Summary of content (8 pages)

PAGE 1
30" FreestandingRange iNSTALLATiON ANDSERVICEMUSTDEPERFORMED BYA QUALiFiED iNSTALLER, iMPORTANT: SAVE THiS iNSTALLATiON MANUAL FOR LOCAL ELECTRICAL iNSPECTOR'S USE, READANDSAVETHESEiNSTRUCTiONSFORFUTUREREFERENCE, For SAFETYCONSiDERATiONSdo notinstall a rangein anycombustibJecabinetrywhichis notin accordwith the stated clearancesand dimensionson page 2. See Figures1 and 2. RANGEMEASUREMENTS ...................................... 2 ELECTRICAL CONNECTIONS ................................
PAGE 2
iNSTALLATiON MANUAL 29 7/8"_ 44 3/8-+1/8" backs )lash 3_ to cooktop surface 42" drawer 6 1/8" 36" J countertop height 6 1/8"/ Maximum depth of cord, plug and "back to front of doors is 4" to prevent 45 3/8" oven door door width interference with lower 7 q,_Lwo,,t \\ preferred electrical outlet area \\ \\\ 30" opening width oven. Figure t Figure Figure 1 contains many range measurements planning your kitchen and/or range location. Provide adeqnate clearances combustible surfaces.
PAGE 3
iNSTALLATiON • t Remove all packing materials from Sealing Surface inside theMicrowave Drawer andtheovenWaveguide cavity. DO NOT Cover REMOVE THE WAVEGUIDE COVER,whichis locatedon thetop of the Microwave Drawer area. 2 Remove thefeature sticker, ifthere isone. Check thedrawer for Before installing the range in an area covered with linoleum or any other synthetic floor covering, make sure the floor covering can withstand heat at least 90°F (32.
PAGE 4
iNSTALLATiON MANUAL Risk of fire or electrical rect size range not followed cord kit is used, precisely stalled range Electrical ; wiring failure " ELECTRICAL ground relief the nuts which to the terminal • DISCONNECT POWER OR FUSE BOX BEFORE CONNECTION. • Electrical a strain block or loss of electrical _ exists or the installation and/or Do not loosen shock if an incor- instructions clamp secure SHOCK are is not used. Figure 5A illustrates 4-wire remodeled installations.
PAGE 5
iNSTALLATION frame Figure where 8. Make sure rear access 3-WIRE the ground all screws cover screw are tightened and secure CONNECTION For existing installations was originally installed. securely with screw. See 3 & 4.WIRE the 3-wire 4-wire and replace See Figure 6. INSTRUCTIONS 2 Connect the end connectors for line 1, line 2 and neutral and tighten securely to the terminal block. See Figure 9.
PAGE 6
|NSTALLAT[ON NORMAL MANUAL iNSTALLATiON Mark the floor or wall where left or right side of the range will be located. If rear of range is against the wall or no further than 1 i/4-inches from wall when installed, you may use the wall or floor mount method. See Figure 13. If molding is installed and does not allow the bracket to fit flush against the wall, remove molding or mount bracket to the floor.
PAGE 7
INSTALLATION 3 LEVEL • AND POS|T|ON RANGE Measure from the countertop to the floor height to determine the height that the back of the range needs to be set at. Loosen legs and lock nuts to set level of the range. (Note that the lock nuts are only on the rear feet). See Figure 15. MANUAL A minimum clearance of t/s-inch is required between the bottom of the range and the leveling leg to allow room for the bracket. Use a level to check your adjustments.
PAGE 8
iNSTALLATiON MANUAL Refer to the Operation Manual for cleaning instructions. If removing the range is necessary for cleaning or maintenance, disconnect the electrical power supply. If the electrical supply is inaccessible, lift the unit slightly at the front and pull out away from the wall. Pull only as far as necessary to disconnect the electrical supply. Finish removing the unit for servicing and cleaning. Reinstall in reverse order making sttre to level the range and check electrical connections.