Installation guide

2 DRILL PILOT HOLES AND FASTEN BRACKET

Drill a t/S-inch pilot hole where screws are to be located. If bracket

is to be mounted to the wall, drill pilot hole at an approximate 20

degree dowmvard angle. If bracket is to be mounted to masonry or

ceramic floors, drill a 5/32-inch pilot hole 1 3/4 inches deep. The

screws provided may be used in wood or concrete material. Use a

5/t6-inch nut-driver or flat head screwdriver to secure the bracket

in place.

wall mount

iNSTALLATiON MANUAL

3 LEVEL AND POSiTiON RAHGE

Level range by adjusting the (4) leveling legs with a wrench.

Note: A minimum clearance of 1/8-inch is required between the

bottom of the range and the leveling leg to allow room for the

bracket. Use a level to check your adjustments. Plug range into

properly prepared electrical receptacle or if hard wired, check that

it was completed properly. Check floor condition for evenness and

stability. Slide range back into position.

floor mount "_ Anti-Tip bracket

Figure t 4

"_I I_ -" more than

leveling leg

1 V4"

Range Slide --,'''/_ _

Figure t6

Visually" check that rear leveling leg is inserted into and fully

secured by the Anti-Tip bracket by looking underneath the range

with a flashlight and carefully attempt to tilt it forward.

Anti-Tip bracket

wall

Figure t7

Slide range in cabinet until control panel edge

is flush with the countertop front edge.