Installation guide

ManualsBrandsSharp ManualsKitchen AppliancesKB-6015KW

MicrowaveDrawer

INSTALLATIONMANUAL

INSTALLATIONANDSERVICEMUSTBEPERFORMEDBYA QUALIFIEDINSTALLER.

IMPORTANT:SAVETHISINSTALLATIONMANUALFORLOCALELECTRICAL

INSPECTOR'SUSE.

READANDSAVETHESEINSTRUCTIONSFORFUTUREREFERENCE.

For SAFETYCONSIDERATIONSdo notinstall drawer in any combustiblecabinetry, which isnot in

accordwith the stated clearances and dimensionson pages2 and 3. See Figures 1 and 2.

UNPACKINGYOURMICROWAVEDRAWER................... 2

IMPORTANTNOTES............................................. 2

IMPORTANTSAFETYINSTRUCTIONS......................... 2

CLEARANCESANDDIMENSIONS.............................. 2

MICROWAVEDRAWERMEASUREMENTS.................... 3

ANTI-TIPBLOCK................................................ 3

ELECTRICALOUTLET........................................... 4

GROUNDINGINSTRUCTIONS................................... 4

DRAWERINSTALLATION....................................... 4

MODELANDSERIALNUMBERLOCATION.................... 4

CARE,CLEANINGANDMAINTENANCE...................... 4

SHARP INSIGHT.PROTM

Summary of content (4 pages)

PAGE 1
MicrowaveDrawer INSTALLATION MANUAL INSTALLATION ANDSERVICEMUSTBEPERFORMED BYA QUALIFIED INSTALLER. IMPORTANT: SAVETHIS INSTALLATION MANUALFORLOCALELECTRICAL INSPECTOR'S USE. READANDSAVETHESEINSTRUCTIONS FORFUTUREREFERENCE. For SAFETY CONSIDERATIONSdo not install drawer in any combustible cabinetry, which is not in accord with the stated clearances and dimensionson pages 2 and 3. See Figures 1 and 2. UNPACKING YOURMICROWAVE DRAWER ................... 2 ELECTRICAL OUTLET ................................
PAGE 2
INSTALLATION MANUAL _To • Remove all packing materials from inside the Microwave Drawer. Drawer block. Sealing which is Remove the feature sticker, if there is one. Check the drawer any damage, misaligned _ Sealing installed Anti-Tip grounded in Surface for _ Oven Cavity such as or bent guides by a properly Never leave children alone or unattended in the area where a Microwave Drawer is in use. Never leave the drawer open when the microwave is unattended.
PAGE 3
INSTALLATION MANUAL 2x4 _n_; J J J Figure 1 Figures 1 and 2 contain many Microwave Drawer measurements for reference when planning the drawer's location. Figure 2 Figure 3 NORMAL ANTI-TIP INSTALLATION STEPS INSTRUCTIONS To reduce the risk of tipping of the drawer, the Anti-Tip block must be properly installed located 14 3/4-inches above the floor on which the Microwave Drawer will sit. The 6-inch 2 x 4 Anti-Tip block must be provided b5 the installer. See Figures l, 2 and 4.
PAGE 4
INSTALLATION MANUAL i]L_][l']l]l]][ *l"_]_[t]l_ l :kd Figure Figure 5 The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more protected electrical supply. It is recommended that a separate circuit serving only this appliance be provided. The drawer is equipped with a 3-prong grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded. Should you only have a 2-prong outlet, have a quail fled electrician install a correct wall receptacle.