Operating Manual

Installation, assembly and commissioning for
the first time
Version 1.1 Page 38 of 92
Only use the provided original cable.
Do not shorten the cable arbitrarily.
Do not extend the cable arbitrarily.
Do not lay the cable in loops.
Immediate surroundings of the battery storage system
The immediate surroundings of batteries must be clean and dry. Oil contaminations, dirt or water residues must not be
found outside the battery. If contaminations are found, remove them immediately. Additional information regarding
this is given in: VDE 0510 Part 2: 2001-12, EN 50272-2: 2001 “Safety requirements for batteries and battery systems –
part 2: stationary batteries”.
4.2 Filling the warranty card
The customer / installer must fill the warranty card carefully; it shall be valid only with a signature and the company
stamp. Send the duly filled warranty card to BMZ GmbH. The warranty card is given in the annexe of this manual.
Guarantee and warranty claims against the manufacturer can be asserted only if the installed battery has been
registered with the manufacturer along with the filled warranty card.
4.3 Filling the installation check list
The installer must fill the installation check list carefully; it shall be valid only with a signature and the company stamp.
Send the duly filled installation check list to BMZ GmbH. The installation check list is given in the annexe of this manual.
Guarantee and warranty claims against the manufacturer can be asserted only if the installed battery has been
registered with the manufacturer along with the filled installation check list.