Operating Manual

Installation, assembly and commissioning for
the first time
Version 1.1 Page 39 of 92
4.4 Installation of the battery storage system
Installation steps
Proceed as follows to install the battery storage system:
Step Description
1 Unpack the battery storage system carefully and check it for transport damage.
In case of transport damage, contact the forwarding agent or the manufacturer immediately.
Do not use a knife to open the packing.
Never install and operate a defective energy storage unit
2 Check whether all structural parts and accessories exist.
3 Check whether the battery storage system has been switched off.
Both LEDs must not light up.
Use a voltmeter to measure the DC voltage.
4 Bring the battery storage system on the pallet to the installation place using suitable transport aids.
5 Check whether the current isolator (NH isolator) is pulled.
Figure 4-3: representation of the pulled current isolator
The current isolator must be pulled before installation.
6 Use a suitable lifting device to lift the battery storage system from the pallet (e.g. workshop crane).
7 Position the battery storage system on the installation site.
Adhere to the minimum distances from walls. (See section 4.1 Requirements for the installation site)