User's Manual

13
www.sharkclean.com
Your Shark
®
Lift-Around™ Canister Vac is
equipped with a protective Motor Thermostat. If the mo-
tor should overheat, the thermostat shuts off the power.
To reset the Motor Thermostat:
Press the Power Button to turn the vacuum off.
Unplug the vacuum.
Check for clogged hose or filter; unclog hose and replace
filter. Refer to Checking for Blockages.
Wait 45 minutes for vacuum to cool; then plug in the
vacuum.
Press the Power Button to restart the vacuum.
Note: If vacuum still does not start, contact Customer
Service at: 1-800-798-7398.
Resetting the Motor Thermostat
Checking for Blockages
Blockages may cause your vacuum to overheat and
shut down. To prevent this from happening, check
potential blockage areas after heavy use or if you
detect a loss of suction or poor cleaning performance.
1 DUST CUP
Dust Cup may be full. Empty Dust Cup.
2 FILTERS (PRE-MOTOR AND POST MOTOR)
Ensure that both the Pre Motor Filters and the Post
Motor HEPA filter are clean.
3 ACCESSORIES
Check intake openings of all the accessories.
4 CLEANING THE POWER BRUSH
• TurnthePowerBrush over, slide the locking latch
forward and tilt the cover upward to remove.
(fig. 22)
• Inspecttherotatingbristlebrush,turbinewheel
and air passage.
• Removeanyblockageordebrisandcarefully,
without damaging the bristles or belt, cut any
build-up of hair or string wrapped around the
rotating bristle brush with scissors.
• Toreassemble,rstinsert
the tabs on the front
edge of the cover into the
matching holes in the top
half of the Power Brush
and tilt the cover back
down pressing until it
clicks into place. (fig. 23)
Locking
Latch
Rotating
Bristle Brush
Turbine
Wheel
Fig. 22
Fig. 23
Ordering Replacement Parts
To order additional parts and accessories, go to
www.sharkclean.com or call 1-800-798-7398.
PART PART NO.
Pre-Motor Filters XFF318
HEPA Filter XHF318
Telescopic Tube 1057FT
Upholstery Brush 1061FT
Crevice Tool 1062FT
Dusting Brush 1063FT
Power Brush 1064FT
Floor Kit Handle XKH320
Canister Caddy XCAD320
Bare floor Nozzle XSN320
LA400_40_IB_ENG_120910_3.indd 13 12-09-10 3:49 PM