Specifications

–12–
2-1 DVCAM VTRs
DSR-2000P
Editing Recorder
•Superb picture quality of the DVCAM format •Playback
capability of all DV (25 Mb/s) recorded tapes including DV
tapes recorded in LP mode and DVCPRO tapes*
1
without
any mechanical adaptor •Long recording time: up to 184
minutes with a standard-size cassette and 40 minutes with a
mini-size cassette •Preread editing capability*
2
to perform
A/B roll editing*
3
with two VTRs and sound-on-sound
capability as well as audio mix/swap and over-dubbing of
audio with no delay between video and audio •Audio cross-
fade function for clean audio transitions at editing points
•VTR-to-VTR editing without external controllers •Wide range
of digital slow speed from –1 to +1 times normal speed •Jog
audio capability •DMC (Dynamic Motion Control) provides
noiseless slow-motion playback •High-speed picture search
over a range of 60 times normal speed, in both forward and
reverse •Versatile digital interfaces: SDI, SDTI (QSDI™)*
4
,
i.LINK™ (DV In/Out)*
5
, SDTI-CP (MPEG Out)*
6
and
AES/EBU digital audio •Extensive analogue interfaces:
composite, component, S-Video and XLR audio •RS-422A
remote control interface •Frame accurate editing capability
•ClipLink™ operation •Full tape dubbing with ClipLink Log
Data via SDTI (QSDI) and RS-422A interfaces •16:9 aspect
ID signal recording •Process control for highly stable video
signals •Built-in EBU time code and VITC generator/reader
•Channel condition monitoring function •Built-in signal
generator •Audio level control in both recording and playback
modes •Dial menu operation •Key Inhibit and Rec Inhibit
functions to prevent accidental operation •Flexible input
selection between video and audio*
7
•Universal powering
system from AC 100 V to 240 V •Triple-size cassette
compartment to ensure compatibility with DV (25 Mb/s)
recorded tapes of all sizes and types •DSBK-200 Control
Panel for remote operation from a distance of up to 10
metres (approx. 33 ft.)
*1 Not compatible with the SDTI (QSDI) and i.LINK interfaces.
*2 Not available through the SDTI (QSDI) and i.LINK interfaces.
*3 MIX and WIPE only
*4 The SDTI (Serial Data Transport Interface) is defined as SMPTE 305M.
The SDTI (QSDI) is the DV compressed signal interface which is defined as SMPTE 322M.
*5 i.LINK stands for IEEE1394-1995 standards and their revisions.
is the logo for products that implement i.LINK.
The optional DSBK-190 i.LINK/DV Input/Output Board is required.
*6 The optional board will be available in the future.
*7 i.LINK cannot be combined with other signal interfaces.
When SDTI (QSDI) is selected as the audio input, the video signal is assumed to be
SDTI (QSDI).
However, when it is selected as the video input, other signal interfaces can be selected
for the audio input.
Supplied Accessories: AC power cord
Operating instructions
RCC-5G 9-pin remote control cable
Optional Accessories: i.LINK/DV Input/Output Board DSBK-190
Control Panel DSBK-200
Control Panel Case BKNW-121
Rack Mount Kit RMM-130
TBC Remote Control Unit UVR-60P
Remote Control Cable RCC-5G/10G/30G (5 m/10 m/30 m)
DV Cable CCF-3L (6-pin - 6-pin), CCFD-3L (6-pin - 4-pin)
Specifications
General
Power requirements: AC 100 to 240 V, 50/60 Hz
Power consumption: 110 W
Operating temperature: 5 °C to 40 °C (41 °F to 104 °F)
Storage temperature: -20 °C to 60 °C (-4 °F to 140 °F)
Operating humidity: Less than 80%
Storage humidity: Less than 90%
Mass: 18 kg (39 lb 10 oz)
Dimensions: 427 (W) × 175 (H) × 496.5 (D) mm
(16
7
/8 × 7 × 19
5
/8 inches)
Tape speed: 28.221 mm/s
Recording/Playback time:
Standard size: 184 min. with PDV-184ME/184N/184MEM
Mini size: 40 min. with PDVM-40ME/40N/40MEM
Fast forward/Rewind time:
Standard size: Less than 3 min. with PDV-184ME/184N/184MEM
Mini size: Less than 1 min. with PDVM-40ME/40N/40MEM
Search speed:
Shuttle mode: Still to ±60 times normal speed in forward and reverse
Digital slow mode: ±1 times normal speed in forward and reverse
Video Performance
Band width (via analogue component I/O):
Luminance: 25 Hz to 5.5 MHz +1.0/-2.0 dB
5.75 MHz +0/-3.0 dB (Typical measurement)
Chrominance: 25 Hz to 2.0 MHz +1.0/-2.0 dB
S/N ratio (via analogue component I/O):
More than 55 dB
K-factor (K2T, KPB): Less than 2.0%
Y/C delay: Less than 30 ns
VIDEOCASSETTE
RECORDERS
Audio Performance
Frequency response:
2CH mode (48 kHz/16-bit):
20 Hz to 20 kHz +0.5/-1.0 dB
4CH mode (32 kHz/12-bit):
20 Hz to 14.5 kHz +0.5/-1.0 dB
Dynamic range: More than 90 dB
Distortion (THD + N): Less than 0.05%
Input Signals
Video (Analogue)
REF. Video (BNC x2, loop-through connection):
Composite, 1.0 Vp-p, 75 Ω, sync negative
Video (BNC x2, loop-through connection):
Composite, 1.0 Vp-p, 75 Ω, sync negative
Component (BNC x3):
Y: 1.0 Vp-p, 75 Ω, sync negative
R-Y: 0.7 Vp-p, 75 Ω (100%)
B-Y: 0.7 Vp-p, 75 Ω (100%)
S-Video (DIN 4-pin x1):
Y: 1.0 Vp-p, 75 Ω, sync negative
C: 0.3 Vp-p, 75 Ω (at burst level)
Video (Digital)
SDI (BNC x2, active-through connection):
Conforms to Serial Digital Interface (270 Mb/s),
ITU-R BT.656
SDTI (QSDI) (BNC x1): Conforms to SDTI (270 Mb/s), SMPTE 305M/322M
i.LINK (DV In/Out) (6-pin x1):
IEEE1394-based
* Using optional DSBK-190 i.LINK/DV Input/Output Board
Audio (Analogue)
Audio (XLR 3-pin female x4):
-6/0/+4 dBu, 600 Ω on/off/-60 dBu, high impedance
Audio (Digital)
AES/EBU (BNC x2): 75 Ω, unbalanced
Time Code
Time Code In (BNC x1): 0.5 Vp-p to 18 Vp-p, 3 kΩ, unbalanced
Output Signals
Video (Analogue)
REF. Video (BNC x1): 0.3 Vp-p, 75 Ω, sync negative
Video 1/2/3(SUPER) (BNC x3):
Composite, 1.0 Vp-p, 75 Ω, sync negative
Component (BNC x3):
Y: 1.0 Vp-p, 75 Ω, sync negative
R-Y: 0.7 Vp-p, 75 Ω (100%)
B-Y: 0.7 Vp-p, 75 Ω (100%)
S-Video (DIN 4-pin x1):
Y: 1.0 Vp-p, 75 Ω, sync negative
C: 0.3 Vp-p, 75 Ω (at burst level)
Video (Digital)
SDI (BNC x3): Conforms to Serial Digital Interface (270 Mb/s),
ITU-R BT.656
SDTI (QSDI) (BNC x1): Conforms to SDTI (270 Mb/s), SMPTE 305M/322M
i.LINK (DV In/Out) (6-pin x1):
IEEE1394-based
* Using optional DSBK-190 i.LINK/DV Input/Output Board
Audio (Analogue)
Audio (XLR 3-pin male x4):
+4/0/-6 dBu (selectable by menu)
Monitor (RCA x1): -11 dBu, 47 kΩ, unbalanced (-18 dBFS)
Headphone (JM-60 headphone jack x1):
-∞ to -13 dBu, 8 Ω, unbalanced (-18 dBFS)
Audio (Digital)
AES/EBU (BNC x2): 75 Ω, unbalanced
Time Code
Time Code Out (BNC x1):
2.2 Vp-p, 75 Ω, unbalanced
Remote
RS-422A: D-sub 9-pin (female) (2)
Video Control: D-sub 15-pin (male) (1)
Control Panel: D-sub 15-pin (female) (1)