Specifications

–20–
2-1 DVCAM VTRs
DSR-70P
Portable Editing Recorder
•Superb picture quality of the DVCAM format •Playback
capability of DV recorded tapes (SP mode only) •Long
recording time: up to 184 minutes with a standard-size
cassette and 40 minutes with a mini-size cassette •Compact,
all-in-one package including a 6.4-inch VGA LCD monitor, a
full cut-editing controller with a Jog/Shuttle dial and an audio
speaker •VTR-to-VTR editing as a double deck editor by
docking two DSR-70P units or a DSR-70P and a DNW-A25P
Betacam SX portable editing recorder •Two-camera switching
recording*
1
•Sequential recording for up to six hours in the
double deck configuration •Parallel-run recording to make two
docked DSR-70P units record simultaneously •Audio
mix/swap recording •ClipLink operation: cue up to Mark
In/Cue address, change of Mark In/Out points, change of
OK/NG status and creation of new Mark In/Out points •Full
tape dubbing with ClipLink Log Data via SDTI (QSDI) and
RS-422A interfaces •Versatile digital interfaces: SDI*
2
, SDTI
(QSDI)*
3
and i.LINK (DV In/Out)*
4
•Extensive analogue
interfaces: composite, component*
5
, S-Video and XLR audio
•RS-422A remote control interface •Frame accurate editing
capability •Built-in EBU time code generator/reader •Process
control for highly stable video signals •High-speed picture
search over a range of 32 times normal speed, in both
forward and revers •Digital slow function over a range of 0 to
0.5 times normal speed, in both forward and reverse •Jog
audio capability •Two-way power supply system for operation
on either AC or DC power •16:9 and 4:3 switchable
*1 The optional DSBK-180P Dual Video Input Board is required.
*2 The optional DSBK-160 SDI Input/Output Board is required.
*3 The optional DSBK-150 SDTI (QSDI) Input/Output Board is required.
*4 The optional DSBK-140 i.LINK/DV Input/Output Board is required.
*5 The optional DSBK-170 Analogue Component Input/Output Board is required.
Note: Optional interface boards (DSBK-140/150/160/170) cannot be used in combination
with each other.
However, these boards can be used together with the optional DSBK-180P.
Supplied accessories: Carrying Belt (1)
Operation Manual (1)
Connector Cap ((1) / per interface)
Optional accessories: i.LINK/DV Input/Output Board DSBK-140
SDTI(QSDI) Input/Output Board DSBK-150
SDI Input/Output Board DSBK-160
Analogue Component Input/Output Board DSBK-170
Dual Video Input Board DSBK-180P
Rechargeable Lithium-ion Battery BP-L60A/L90A
Battery Charger for BP-L60A/L90A BC-L50
Battery Charger for BP-L60A/L90A BC-L100CE
AC Adaptor AC-DN2A
AC Adaptor AC-550CE
AC Adapror CMA-8ACE
Remote Control Cable RCC-5G/10G/30G
Docking Kit BKNW-225
Carrying Case LC-DN220
SPECIFICATIONS
GENERAL
Power requirements: DC 12 V
Power consumption: 46 W (without options)
Operating temperature: 0 °C to 40 °C (32 °F to 104 °F)
Storage temperature: -20 °C to 60 °C (-4 °F to 140 °F)
Operating humidity: Less than 80 %
Storage humidity: Less than 90 %
Mass: 5.8 kg (12 lb 12 oz)
Dimensions: 211 (W) × 149 (H) × 443 (D) mm
(8
3
⁄8 × 5
7
⁄8 × 17
1
⁄2 inches)
Tape speed: 28.221 mm/s
Recording/Playback time:
Standard size: 184 min. with PDV-184ME/184N/184MEM
Mini size: 40 min. with PDVM-40ME/40N/40MEM
Fast forward/Rewind time:
Standard size: Less than 3 min. with PDV-184ME/184N
Mini size: Less than 1 min. with PDVM-40ME/40N
Search speed: x32, forward and reverse
Signal Inputs
Video (ANALOGUE)
Ref. Video (BNC x2), loop-through connection):
Composite, 1.0 Vp-p, 75 Ω, sync negative
Video (BNC x2), loop-through connection):
Composite, 1.0 Vp-p, 75 Ω, sync negative
Component (BNC x3)*
1
: Y: 1.0 Vp-p, 75 Ω, sync negative
R-Y: 0.7 Vp-p, 75 Ω (100 %)
B-Y: 0.7 Vp-p, 75 Ω (100 %)
S-Video (DIN 4-pin x1): Y: 1.0 Vp-p, 75 Ω, sync negative
C: 0.3 Vp-p, 75 Ω (at burst level)
VIDEOCASSETTE
RECORDERS
Video (DIGITAL)
i.LINK (DV In/Out) (6-pin x1)*
2
:
IEEE1394-based
SDTI(QSDI) (BNC x1)*
3
: Conforms to SDTI (270 Mb/s), SMPTE305M/322M
SDI (BNC x1)*
4
: Conforms to Serial Digital Interface (270 Mb/s), ITU-R
BT.656
Audio (ANALOGUE)
Audio (CH-1,2): XLR 3-pin female (2)
Signal Outputs
Video (ANALOGUE)
Ref. Video (BNC x1): 0.3 Vp-p, 75 Ω, sync negative
Video 1/2(SUPER) (BNC x2):
Composite, 1.0 Vp-p, 75 Ω, sync negative
Component (BNC x3)*
1
: Y: 1.0 Vp-p, 75 Ω, sync negative
R-Y: 0.7 Vp-p, 75 Ω (100 %)
B-Y: 0.7 Vp-p, 75 Ω (100 %)
S-Video (DIN 4-pin x1): Y: 1.0 Vp-p, 75 Ω, sync negative
C: 0.3 Vp-p, 75 Ω (at burst level)
Video (DIGITAL)
i.LINK (DV In/Out) (6-pin x1)*
2
*
5
:
IEEE1394-based
SDTI(QSDI) (BNC x1)*
3
: Conforms to SDTI (270 Mb/s), SMPTE305M/322M
SDI (BNC x2)*
4
: Conforms to Serial Digital Interface (270 Mb/s), ITU-R
BT.656
Audio (ANALOGUE)
Audio (CH-1,2 or CH-3,4): XLR 3-pin female (2)
Audio monitor (R/L): RCA phono jack (1)
Headphones: JM-60 stereo phone jack (1)
Time Code
Time code input: BNC (1)
Time code output: BNC (1)
LCD
LCD display (1) 6.4-inch VGA, 640 (H) x 480 (V)
Speaker
Built-in speaker (1) Monaural
Remote
RS-422A D-sub 9-pin (female) (1)
Others
DC 12 V input: XLR 4-pin (1)
*1 Using optional DSBK-170 Analogue Component Input/Output Board
*2 Using optional DSBK-140 (i.LINK/DV Input/Output Board)
*3 Using optional DSBK-150 (SDTI(QSDI) Input/Output Board)
*4 Using an optional DSBK-160 (SDI Input/Output Board)
*5 Shared with input connector
(without optional interface boards)