Operation Manual

TV menu
E
Step 3: Automatic installation
Your TV searches and stores all available digital and
analogue TV channels as well as all available digital
radio channels.
Press
1. TV MENU on the remote control and
select
≥ Channel Set Up. Then press OK
or
.
NOTE
You are prompted to enter current password to enter •
Channel Set Up if Channel Block in the Parental
menu is not the default setting.
Select 2. Auto Scan ≥ Start and press OK or
to start channel installation. The installation
may take a few minutes.
When complete, follow the on-screen
3.
instructions to exit.
Update Scan
Update Scan has similar function with Auto Scan.
The difference is you could update channel list without
erasing the original information.
Press
1. TV MENU on the remote control and
select
≥ Channel Set Up. Then press OK
or
.
NOTE
You are prompted to enter current password to enter •
Channel Set Up if Channel Block in the Parental
menu is not the default setting.
Press 2. / to select Update Scan ≥ Start
and press OK or
to start channel update.
When complete, follow the on-screen
3.
instructions to exit.
Manual Scan
If using digital broadcasts, you can add new services
and check the quality and signal strength of digital
channels. This allows you to reposition and test your
antenna or satellite dish.
Press
1. TV MENU on the remote control and
select
≥ Channel Set Up. Then press OK
or
.
NOTE
You are prompted to enter current password to enter •
Channel Set Up if Channel Block in the Parental
menu is not the default setting.
Press 2. / to select Manual Scan and press
OK or
to enter.
Highlight the
3. RF Channel box, and press ◀ /
to select a channel number you preferred to
scan.
Press
4. OK to start scanning.
Picture
Option
Lock
RF Channel
Signal Strength
Signal Quality
100
100
6
Status: Scan Complete
Digital Channels: 7
100%
When the scan is completed, the result of 5.
Signal Strength and Signal Quality appear on
the screen. The scanned channel is added in
the channel list.
Follow the on-screen instructions to exit.
6.
NOTE
You can also check Signal Strength and Signal •
Quality in Signal Status menu.
If the signal quality and strength is poor, reposition •
the antenna or satellite dish and retest.
If you have further problems with the reception of •
your digital broadcast, contact a specialised installer.
Channel Skip
Channel skip allows you to skip one or more channels
when pressing P <> on the remote control to switch
between channels.
Press
1. TV MENU on the remote control and
select
≥ Channel Set Up. Then press OK
or
.
NOTE
You are prompted to enter current password to enter •
Channel Set Up if Channel Block in the Parental
menu is not the default setting.
Press 2. / to select Channel Skip and press
OK or
to enter the channel list.
Press
3. / to select one or more channels you
preferred to skip.
Press
4. OK to mark or cancel.
Follow the on-screen instructions to exit.
5.
NOTE
To watch the skipped channels, enter the channel •
numbers by using the digit buttons on the remote
control or select from channel list.
If you perform Auto Scan, your stored settings will be •
erased and you will have to perform this operation again.
15
54B0101C_English.indd 1554B0101C_English.indd 15 5/22/2010 09:57:065/22/2010 09:57:06