Manual

Watching TV
You can change channels in several ways by pressing
AiR or CABLE to select the antenna and then following
one of the methods below,
@QQ
®Q®
@®®
AIR CABLE INPUT FJGHB,_C_
@@@@
vo_ CH
Method 4
1. Press INPUT.
2. Press _,/_ to select CableBox [TV], and then press
ENTER.
Method 1
Using CH/X./V on the remote control unit or on the TV.
Method 2
1. Press FLASHBACK to switch to the previously tuned
channel.
2. Press FLASHBACK again to switch back to the
currently tuned channel.
CableBox [TV]
3. Press CH/X./V to change the channel of the cable
box.
,, FLASHBACK will not work if no channel has been
changed after TV is turned on.
Method 3
Using remote control buttons (0=9, ,* (DOT) to select
channels for VHF/UHF/CATV/DIGITAL
To select a 1 or 2-digit channel number
(e, g,, Channem 5):
Press 5--> ENT
,, When selecting a 1-digit channel number, it is not
necessary to press 0 before the number,
,, When you enter 0=9 orfly, channel selection will be made
if there is no operation for a few seconds.
To select a 3-digit channel number
(e, g,, Channel 115):
Press 1-->1 -->5
To select a 4-digit channel number
(e. g., Channel 22.1):
Press 2 -+2-+e (DOT) -->1--> ENT
(_ -34
,, When you enter 0=9 only, channel selection will be made
if there is no operation for a few seconds.
,, If you push "0" by itself, nothing will happen,
,, Complete the above steps wkhin a few seconds.
,, When you enter 0=9 and ,, (DOT) channel selection will
be made if there is no operation for a few seconds,