Manual
Appendix
Before detaching (or attaching) the stand, unplug the AC cord from the AC INPUT terminal.
• Do not remove the stand from the "iV unless using an optional wall mount bracket to mount it.
Before attaching/detaching the stand
Before performing work make sure to turn off the TV.
Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being
damaged.
Unfasten the four screws used to secure the stand in
place.
2
Detach the stand from the TV. (Hold the stand so it
will not drop from the edge of the base area.)
+ To attach the stand, perform the above steps in reverse order.
• This "IV should be mounted on the wall with both the AN-37AG2 (SHARP} wall mount bracket and the AN-37P30
(SHARP} attachment of the wall mount bracket. The "iV cannot be mounted when with only the AN-37AG2 wall mount
bracket. The use of other wall mount brackets may result in an unstable installation and may cause serious injuries.
,,installing the TV requires special skill that should only be performed by qualified service personnel. Customers
should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or mounting
that results in accident or injury.
Using an optional bracket to mount the TV
You can ask a qualified service professional about using an optional AN-37AG2 bracket to mount the TV to the wall.
Carefully read the instructions that come with the bracket before beginning work.
Hanging on the wall
AN-37AG2 wall mount bracket.
(See the bracket instructions for details.)
Vertical mounting Angular mounting
About setting the TV angle
• The center of the
°°]_°]+°°]ls°]2°° display: 1111+inch (17.3
mm) under the "A"
position. Refer to the
operation manual of AN-
37P30 for details.
+ Detach the cable clamp on the rear of the TV when using the optional mount bracket.
+ Due to the terminal configuration on this TV, when you wall-mount this model, make sure there is enough space between the
wall and the TV for the cables.
+ To use this TV mounted on a wall, first remove the adhesive tape at the 4 locations on the rear of the TV, and then use the
screws supplied with the wall mount bracket to secure the bracket to the rear of the TV.
Q- 6o