Manual

Preparation
Use the remote control unit by pointing ittowards the remote control sensor on the
TV. Objects between the remote control unit and the remote control sensor may
prevent proper operation.
• Do not expose the remote control unit to shock, in addition, do not expose the remote
control unit to liquids, and do not place in an area with high humidity.
• Do not install or place the remote control unit under direct sunlight. The heat may cause
deformation of the remote control unit.
• The remote control unit may not work properly if the remote control sensor on the TV is
under direct sunlight or strong lighting, in such cases, change the angle of the lighting or
the %/, or operate the remote control unit closer to the remote control sensor.
/
To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections
that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with an F-type connector,
plug it into the antenna terminal at the rear of the TV set,
"1. A 75+ohmsystem is generallya round cablewith Fqype "_
connector that can easilybe attachedto a terminal
without tools (Commemiallyavailable).
F-type connector
75+ohm coaxial cable (round)
2. A 300+ohm system is a flat "twinqead" cable that can be
attached to a 75+ohm terminal through a 300/75+ohm
adapter (Commemially available).
300+ohm twimlead cable (flat)
_., J
r
Connecting Antenna Cable
Cable without a CA'IV
converter
VHF/UHF antenna
Combination VHF/
UHF antenna
Separate VHF/UHF
antenna
_ -type connector should be finger -_
tightened only.
When connecting the RF cable to the TV set, do not
tighten F-type connector with tools.
If tools are used, it may cause damage to your TV
set, (The breaking of internal circuit, etc.)
Home Antenna
terminal (75 ohm)
[2 _ =
Ce_;al cable
(commeroial_y available)
F4ype connector
75+ohm coaxial cable
Home AntelTna
terminal (75 ohm)
Ce_;al cable
(commeroial_y available)
_ ohrr7 coaxial cable (round) _[]_
300/75-ohm adapter
VHF UHF (commercially available)
ANTENNA ANTENNA
• Connect the antenna cable
to the TV using one of the
methods in the illustration
as shown (_, _, _ or _).
To TV antenna _1
terminal
Q- 12