Manual

Watch ing TV
You can change channels in several ways by pressing
AIR or CABLE to select the antenna and then following
one of the methods below.
QOO
®O®
QO®
®@O
AIR OAB/F INPUT Ft_BACK
@@®®
vo OH
PAGE
Method 1
Using CHA/V on the remote control unit or on the TV.
Method 4
1. Press INPUT.
2. Press A/V to select CableBox [TV], ant1 then press
ENTER.
Method 2
1. Press FLASHBACK to switch to the previously tuned
channel.
2. Press FLASHBACK again to switch back to the
currently tuned channel.
3. Press CHA/V to change the channel of the cable
box.
• FLASHBACK will not work if no channel has been
changed after TV is turned on,
Method 3
Using rernote control buttons 0-9, • (DOT) to select
channels for VHF/U HF/CATV/DIGITAL.
To select a 1 or 2-digit channel number
(e. g., Channel 5):
Press 5-> ENT
• When selecting a 1=digit channel number, it is not
necessary to press 0 before the number.
• When you enter 0-9 only, channel selection will be made
ir there is no operation for a few seconds,
To select a 3-digit channel number
(e. g., Channel 115):
Press 1-->1->5
To select a 4-digit channel number
(e. g., Channel 22.1):
Press 2 ->2->. (DOT) ->1 -> ENT
• When you enter 0-9 only, channel selection will be made
if there is no operation for a few seconds,
• Iryou push "0" by itself, nothing will happen,
• Complete the above steps within a few seconds,
• When you enter 0-9 and • (DOT), channel selection will
be made if there is no operation for a few seconds,
Q -33