Manual

QUICK REFERENCE
TV GUIDE ON SCREEN TM QUICK SETUP SHEET
Once you set up the TV according to this operation manual, you are ready to set up TV Guide On Screen!
Note: TV Guide On Screen TM interactive program guide supports cable-ready, cable box and digital cable
services as well as over-the-air broadcast, It does not provide listings for satellite services,
After completing the TV's initial set up, you see the TV
Guide On Screen Setup Welcome Screen,
Note: IfTV Guide On Screen is not set up, pressing TV
GUIDE while watching TV will display the Welcome
Screen.
Follow the on-screen instructions
If you previously skipped TV Guide On Screen setup,
you see the Reminder Screen.
Find the VCR and Cable Box IR Sensors.
To control recording, find the VCR's IR sensor,
Turn the VCR off.
Hold the VCR remote so that it touches the
front or the VCR (Figure 1).
Move the remote across the front while
pressing POWER (Figure 2). (You must press
and release the power button each time you
move the remote; holding down the button will
not work).
_} When the VCR powers on, you have round
the sensor.
_5_Remember the location orthe sensor, and go
to step 3.
If you have a cable box, repeat this procedure
using the cable box and its remote, and then
go to step 3.
Figure 1
Correct Incorrect
Figure 2
Note: If you press ENTER and the screen does not
change, make sure that the batteries in the remote
control are properly installed,
If you need to control a cable box and/or a VCR,
complete steps 1 through 3, If not, go to step 4,
Find and Connect the included G-LINK cable
into the G-LINK terminal.
G-LINK cable with
Double-Sided Tape
Place the G-LINK cable(s)
To control a VCR, place one of the G-LINK
wands underneath the VCR approximately 1
inch in front of the sensor you found in step 2,
If you have a cable box, place the other G-
LINK wand approximately 1 inch in front of
the sensor you found in step 2,
Use the double-sided tape to secure each
G-LINK cable,
This end is connected to the TV as
G-LINK cable--
Use the TV remote for On-Screen Setup
Press A/I'/</I_ and ENTER to highlight an
item in a Setup screen.
Press ENTER to select that item=
II II
. A/_'/</1_
ENTER
(_)-9